Behringer MX9000 user manual Aux sends post EQ, MIX-B source post fader, LED meters pre fader

Page 51

24.1 Aux sends > post EQ

All channel aux sends are post mute and pre fader. If you want to convert these to post EQ, carry out the following modification to each channel. You will find a corresponding printing on the PCB (see fig. 24.1).

1.Disconnect power supply.

2.Cut the “post mute” track.

3.Add in a “post EQ” link.

4.Repeat for all channels you want to be modified.

Fig. 24.1: Modifications aux send > post EQ

24.2 MIX-B source > post fader

That's it. You've decided to use the MIX-B as a stereo aux send to FX rather than a separate stereo feed. You can move the tap from the A-channel from pre to post the channel fader as follows. Again, look for the printing on the PCB shown below.

1.Disconnect power supply.

2.Cut the “pre” track.

3.Add in a “post” link.

4.Repeat for all channels you want to be modified.

Fig. 24.2: Modifications MIX-B source > post fader

24.3 LED meters > pre fader

In channel mode the meterbridge monitors the DIRECT OUT signal (post EQ, post mute and post fader). You would prefer to see what's going on pre mute and pre fader? Once you found the corresponding printing on the PCB, all you have do is:

1.Disconnect power supply.

2.Cut the “line out” track.

3.Add in a “pre fade” link.

4.Repeat for all channels you want to be modified.

Fig. 24.3: Modifications LED meters > pre fader

51

Image 51
Contents Eurodesk MX9000 Detailed Safety Instructions Safety InstructionsForeword Table of Content Track Recording with 2 Samplers Eurodesk Overview ManualMetering PSU Power Supply UnitInput switching INPUT/OUTPUT ChannelChannel strip Channel input switching architecture Input gain settingAux sends Main equalizerAux sends Routing and mutingRouting ChannelB-channel InsertsSubgroups Subgroup and Direct OutputsStereo subgroup channel schematic Master Panel Direct outputsAux masters Aux sends Stereo aux returns Mix-B MIX-B masterMonitoring MonitoringPhones HeadphonesTalkback PFL/SOLORear panel ConnectionsPower supply unit connector Subgroup inserts Main balanced outputs 10 MIX-B operating level switch and phantom power switch Plug soldering guide Page Patchfield Normalized bayPatchfield Example of patchbay configurations Wiring for bay 8 for advanced wiring scheme refer to section Looming problemsEqualization Gain Optimization Unbalanced Lines Impedances and TuningSTART-UP Channel setting up procedureDesk/tape setting up procedures Track Midi SUITE/DANCE Production Studio Sends Auxless headphones mixReturns Slightly more complicated auxless headphones mixRecording Track Recording with 2 SamplersLining up record/sample inputs MixdownProfessional 24-TRACK Studio HeadphonesTab .1 Channel assignment Very tricky headphones Live P.A. with 2-TRACK RecordingWet monitoring Tab .1 Channel assignments 2-track Live Concert with 24-TRACK Recording Tab .2 Front/rear/stage monitors routing Alignment Expanding the Eurodesk MX9000Timecode ConnectionsSequencing Live BouncingModifications INPUT/OUTPUT ConfigurationAux sends post EQ MIX-B source post faderLED meters pre fader Specifications DBr ref. +4 dBu, 24 chs. assigned input B & set @ unity gain § 1 Warranty CARD/ONLINE Registration WarrantyPage
Related manuals
Manual 57 pages 34.68 Kb