Euphonix EuCon manual Physically Linking Artist Series Devices

Page 14

USER GUIDE

14

SETUP AND INSTALLATION

professional control surface

Two larger, detached riser brackets elevate and angle the unit more than the foldout legs. Use moderate force to snap them into the bottom panel as shown in Figure 2-1.

To remove the riser brackets:

1.Slide the side panels off (Figure 2-2left).

Figure 2-2Removing side panels (left); removing riser brackets

2.Press the tabs to release the riser brackets (Figure 2-2right).

3.Lift the riser bracket out of the MC Mix to remove

2.1.2Physically Linking Artist Series Devices

MC Mixes can be physically attached to each other to form a larger, stable control surface. An MC Control can also be joined to the MC mixes. See Surfaces on page 41 to use EuControl to link the surfaces in the desired order.

Artist Series

Image 14

Contents User Guide Communications and Safety Regulation Information User GuideJapan CanadaEuropean Union Australia Important Safety Instructions User Guide Page Table of Contents Viii List of Figures Page Introduction to the Artist Series EuControl SoftwareConventions Used in this User Guide Setting Up the MC Mix Elevating the MC MixPhysically Linking Artist Series Devices 2Removing side panels left removing riser brackets3Removing screws from the bottom panel Installation 6Menu bar with EuControl icon8Ethernet cable and rear panel jack Controlling a Second Workstation Connecting a Footswitch 10 Footswitch input on rear panelPage Common Tasks Fader StripPress the Home key -2to restore tracks 1-8 to strips Inserts Fader strip, Inserts and Chan keysPress the page keys to access more parameters Figure Chapter Power Switch Shift KeyOled Dimming Fader StripsDisplay Screens Solo Fader3 on Transport Controls REW6 SEL 30 4.3.7 AssignFader Navigation Controls Bank and NudgeNavigating Among Multiple MC Mixes Not all applications support these keysKnobs Basic Knob UseKnob Modes Normal ModeChannel Mode Chan KeyKnob Set Selector Keys 11Knob Selector keysMIX Knob Set Navigation Keys Configuration Pages CFGDual-Function Knobs User Guide Knob Sets and Multiple MC Mixes BackUser Guide Surfaces EuControlAdd B All SurfacesMy Surfaces Show Info WorkstationsRemove Attach/Detach All WorkstationsMy Workstations General General PreferencesSolo Mode Preferences 46 5.4 Preferences EuControlMC Control Display FootswitchMC Mix display screen dim time OperationAssign Assign tabClear All LayoutsDisplay application’s track numbers RecallClear Appendix a Setting the IP Address Professional control surface