Euphonix EuCon manual Fader, 3 on, Solo

Page 28

USER GUIDE

28

SURFACE CONTROLS

professional control surface

4.3.2Fader

The fader controls the track assigned to this strip. It is motorized so it reflects changes made in the application, such as automation. It is also touch sensitive, which some applications use when automating.

SOLO ON

	12
AUTO	6
REC N
	0
	5
ASSIGN
SEL Y

10

20

30

40

60

8

Figure 4-3 Fader strip

When the Select by Touch General preference is selected (page 45), touching a fader selects that track in the application and attentions it on that strip. This is the same as pressing the fader Sel key.

4.3.3ON

The track is on (unmuted) when the strip’s On key is lit and off (muted) when the strip’s On key is not lit.

4.3.4SOLO

The SOLO key lights red when that strip’s track is soloed and is unlit otherwise.

Artist Series

Image 28

Contents User Guide Communications and Safety Regulation Information User GuideEuropean Union Australia CanadaJapan Important Safety Instructions User Guide Page Table of Contents Viii List of Figures Page Introduction to the Artist Series EuControl SoftwareConventions Used in this User Guide Setting Up the MC Mix Elevating the MC MixPhysically Linking Artist Series Devices 2Removing side panels left removing riser brackets3Removing screws from the bottom panel Installation 6Menu bar with EuControl icon8Ethernet cable and rear panel jack Controlling a Second Workstation Connecting a Footswitch 10 Footswitch input on rear panelPage Common Tasks Fader StripPress the Home key -2to restore tracks 1-8 to strips Inserts Fader strip, Inserts and Chan keysPress the page keys to access more parameters Figure Chapter Power Switch Shift KeyDisplay Screens Fader StripsOled Dimming 3 on FaderSolo Transport Controls REW6 SEL 30 4.3.7 AssignFader Navigation Controls Bank and NudgeNavigating Among Multiple MC Mixes Not all applications support these keysKnobs Basic Knob UseNormal Mode Channel ModeKnob Modes Chan KeyKnob Set Selector Keys 11Knob Selector keysMIX Dual-Function Knobs Configuration Pages CFGKnob Set Navigation Keys User Guide Knob Sets and Multiple MC Mixes BackUser Guide Surfaces EuControlMy Surfaces All SurfacesAdd B Remove WorkstationsShow Info My Workstations All WorkstationsAttach/Detach General General PreferencesSolo Mode Preferences 46 5.4 Preferences EuControlFootswitch MC Mix display screen dim timeMC Control Display OperationAssign Assign tabLayouts Display application’s track numbersClear All RecallClear Appendix a Setting the IP Address Professional control surface