Euphonix EuCon manual Controlling a Second Workstation

Page 18

USER GUIDE

18

SETUP AND INSTALLATION

professional control surface

8.Press and release the POWER switch on your MC Mix.

Look at the top-right of your screen and wait up to 60 seconds. A green icon

in the menu bar indicates correct installation. If you did not see the green icon:

•See My Surfaces on page 42 and add the MC Mix manually.

•Shut down the MC Mix and the Mac and repeat steps 7 and 8.

•If your Mac is pre-2002 and you are using an Ethernet router or switch, you need to purchase a normal straight-through Ethernet cable (instead of the crossover Ethernet cable supplied) from a computer store.

•See www.euphonix.com/artist/support for the most current trouble- shooting information.

9.Launch your application and open a project (Logic, Cubase, Digital Performer, Pro Tools, etc.).

10.To set up your application to work with the MC Mix, refer to the EuCon Ap- plication Setup Guide that you downloaded at the beginning of this section.

Logic users do not need this document because additional setup is not required.

Controlling a Second Workstation

The MC Mix can control applications running on a second computer, referred to in this guide as a workstation. Most users will not need to do this because EuControl will be running on the same workstation as the their audio/video applications.

Insert the installation CD into your Macintosh or, if you downloaded the latest software from the web, double-click on the installer. Follow the instructions to install the software.

Copy the latest software that you downloaded at the beginning of this chapter over to the second workstation. Double-click the Install EuCon Workstation installer in the Extras folder and follow the instructions to install the EuCon software.

Artist Series

Page 17 Page 19
Image 18
Page 17 Page 19
Contents User Guide Communications and Safety Regulation Information User GuideCanada European Union AustraliaJapan Important Safety Instructions User Guide Page Table of Contents Viii List of Figures Page Introduction to the Artist Series EuControl SoftwareConventions Used in this User Guide Setting Up the MC Mix Elevating the MC MixPhysically Linking Artist Series Devices 2Removing side panels left removing riser brackets3Removing screws from the bottom panel Installation 6Menu bar with EuControl icon8Ethernet cable and rear panel jack Controlling a Second Workstation Connecting a Footswitch 10 Footswitch input on rear panelPage Common Tasks Fader StripPress the Home key -2to restore tracks 1-8 to strips Inserts Fader strip, Inserts and Chan keysPress the page keys to access more parameters Figure Chapter Power Switch Shift KeyFader Strips Display ScreensOled Dimming Fader 3 onSolo Transport Controls REW6 SEL 30 4.3.7 AssignFader Navigation Controls Bank and NudgeNavigating Among Multiple MC Mixes Not all applications support these keysKnobs Basic Knob UseKnob Modes Normal ModeChannel Mode Chan KeyKnob Set Selector Keys 11Knob Selector keysMIX Configuration Pages CFG Dual-Function KnobsKnob Set Navigation Keys User Guide Knob Sets and Multiple MC Mixes BackUser Guide Surfaces EuControlAll Surfaces My SurfacesAdd B Workstations RemoveShow Info All Workstations My WorkstationsAttach/Detach General General PreferencesSolo Mode Preferences 46 5.4 Preferences EuControlMC Control Display FootswitchMC Mix display screen dim time OperationAssign Assign tabClear All LayoutsDisplay application’s track numbers RecallClear Appendix a Setting the IP Address Professional control surface
Top Page Image Contents