Euphonix EuCon manual 3Removing screws from the bottom panel

Page 15

professional control surface

To join two MC Mixes:

1.On one of the MC Mixes, use a #2 Phillips screwdriver to remove the two silver screws (Figure 2-3).

The screws may be tight, so you may have to use some force.

Figure 2-3Removing screws from the bottom panel

2.Lift the black plastic connecting part and side panel up and out of the MC Mix (Figure 2-4).

Figure 2-4Removing connecting part and side panel

3.On the second MC Mix, remove the side panel (see Figure 2-2left) on the end where it will attach to the first MC mix.

4.Slide the connecting part of the second MC Mix into first MC Mix to attach them together (Figure 2-5).

Figure 2-5MC Mixes attached by connecting at side panel

USER GUIDE

15

SETUP AND INSTALLATION

Artist Series

Image 15
Contents User Guide User Guide Communications and Safety Regulation InformationCanada European Union AustraliaJapan Important Safety Instructions User Guide Page Table of Contents Viii List of Figures Page EuControl Software Introduction to the Artist SeriesConventions Used in this User Guide Elevating the MC Mix Setting Up the MC Mix2Removing side panels left removing riser brackets Physically Linking Artist Series Devices3Removing screws from the bottom panel 6Menu bar with EuControl icon Installation8Ethernet cable and rear panel jack Controlling a Second Workstation 10 Footswitch input on rear panel Connecting a FootswitchPage Fader Strip Common TasksPress the Home key -2to restore tracks 1-8 to strips Fader strip, Inserts and Chan keys InsertsPress the page keys to access more parameters Figure Chapter Shift Key Power SwitchFader Strips Display ScreensOled Dimming Fader 3 onSolo REW Transport Controls30 4.3.7 Assign 6 SELBank and Nudge Fader Navigation ControlsNot all applications support these keys Navigating Among Multiple MC MixesBasic Knob Use KnobsChan Key Normal ModeChannel Mode Knob Modes11Knob Selector keys Knob Set Selector KeysMIX Configuration Pages CFG Dual-Function KnobsKnob Set Navigation Keys User Guide Back Knob Sets and Multiple MC MixesUser Guide EuControl SurfacesAll Surfaces My SurfacesAdd B Workstations RemoveShow Info All Workstations My WorkstationsAttach/Detach General Preferences General46 5.4 Preferences EuControl Solo Mode PreferencesOperation FootswitchMC Mix display screen dim time MC Control DisplayAssign tab AssignRecall LayoutsDisplay application’s track numbers Clear AllClear Appendix a Setting the IP Address Professional control surface