Euphonix EuCon manual Mix

Page 36

USER GUIDE

36

SURFACE CONTROLS

professional control surface

INSERTS

Pressing the INSERTS key displays the inserts knob set for editing plug-ins. In normal mode, the first plug-in is displayed on the knob. Pressing one of these Knob Tops in normal mode toggles the MC Mix into channel mode and displays the first eight plug-in parameters for editing. Pressing a plug-in’s Knob Top displays its parameters for editing.

EQ

Press the EQ key to display the EQ knob set to configure equalization controls and filters. This automatically toggles the MC into channel mode and shows four EQ bands on eight knobs.

AUX

Press the AUX key to display the Aux knob set to control auxiliary sends. In normal mode, the first aux send is displayed. In normal mode, press the PAGE X key to advance to the second aux send. In channel mode, up to eight aux sends can be shown at once.

PAN

Press the PAN key to display the Pan knob set to configure left/right or surround panning. In normal mode, the left/right pan control is typically displayed. In channel mode, the first page of eight pan knobs is shown.

INPUT

Press the INPUT key to display the Input knob set to configure input routing, mic gains, phantom power, and other application-specific parameters.

DYN

Press the DYN key to display the Dynamics knob set to configure compressors, limiters, expanders, and gates.

GROUP

Press the GROUP key to display the Group knob set to configure group bus routing or control group (VCA) membership.

MIX

Press the MIX key to display the Mix knob set to configure output routing.

Artist Series

Page 35 Page 37
Image 36
Page 35 Page 37
Contents User Guide Communications and Safety Regulation Information User GuideCanada European Union AustraliaJapan Important Safety Instructions User Guide Page Table of Contents Viii List of Figures Page Introduction to the Artist Series EuControl SoftwareConventions Used in this User Guide Setting Up the MC Mix Elevating the MC MixPhysically Linking Artist Series Devices 2Removing side panels left removing riser brackets3Removing screws from the bottom panel Installation 6Menu bar with EuControl icon8Ethernet cable and rear panel jack Controlling a Second Workstation Connecting a Footswitch 10 Footswitch input on rear panelPage Common Tasks Fader StripPress the Home key -2to restore tracks 1-8 to strips Inserts Fader strip, Inserts and Chan keysPress the page keys to access more parameters Figure Chapter Power Switch Shift KeyFader Strips Display ScreensOled Dimming Fader 3 onSolo Transport Controls REW6 SEL 30 4.3.7 AssignFader Navigation Controls Bank and NudgeNavigating Among Multiple MC Mixes Not all applications support these keysKnobs Basic Knob UseNormal Mode Channel ModeKnob Modes Chan KeyKnob Set Selector Keys 11Knob Selector keysMIX Configuration Pages CFG Dual-Function KnobsKnob Set Navigation Keys User Guide Knob Sets and Multiple MC Mixes BackUser Guide Surfaces EuControlAll Surfaces My SurfacesAdd B Workstations RemoveShow Info All Workstations My WorkstationsAttach/Detach General General PreferencesSolo Mode Preferences 46 5.4 Preferences EuControlFootswitch MC Mix display screen dim timeMC Control Display OperationAssign Assign tabLayouts Display application’s track numbersClear All RecallClear Appendix a Setting the IP Address Professional control surface
Top Page Image Contents