OPERATING INSTRUCTIONS
COPY OF THE LIGHTING PLATE INSTRUCTIONS
FOR YOUR SAFETY
READBEFORE LIGHTING
This appliance must be installed in accordance with local codes, if any; if not, follow the current
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. Improper installation, adjustment, alteration, service or maintenance can cause injury orproperty damage.Refertotheowner’s information manual provided with this appliance. For assistance or additional information consult a qualified installer, service agency or gas supplier.
A)This appliance has a pilot which must be lighted by hand, following the instructions below exactly.
B)BEFORE LIGHTING smell all around the appli- ance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
-Do not try to light any appliance
-Do not touch any electric switch, do not use any phone in your building
-Immediately call yourgassupplierfroma neigh- bours phone. Follow the gas supplier’s instruc- tions.
-If you cannot reach your gas supplier, call the fire department.
C)Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D)Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
This appliance needs fresh air for safe operation and must be installed so there are provisions for adequate combustion and ventilation air.
CAUTION: Hot while in operation. Do not touch. Due to high surface temperatures keep children, clothing and furniture, away. Keep burner and control compartment clean.
See installation and operating instructions accompanying appliance.
LIGHTING INSTRUCTIONS 
STOP! Read the safety information above on this label.
1)Push in gas control knob slightly and turn clock-
wise 
to “OFF”. Knob cannot be turned from “PILOT” to “OFF” unless knob is pushed in
slightly. Do not force.
2)Wait five (5) minutes to clear out any gas. If you then smell gas STOP! follow “B” in the safety information above on this label. If you don’t smell gas, go to the next step.
3)Turn knob on gas control counterclockwise 
to “PILOT”.
4)Push in control knob all the way and hold in. Immediately push black button on spark igniter until pilot lights. Continue to hold the control knob in for about 1/2 minute after the pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 3) and 4).
If knob does not pop up when released, stop and immediately call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.
5)Turn gas control knob counterclockwise
to “ON”.
6)Use rocker switch to operate main burner.
TO TURN OFF GAS APPLIANCE 
1)Push in the gas control knob slightly and turn
clockwise 
to “OFF”. Do not force.
2)Turn off all electric power to the appliance if service is to be performed.
DO NOT REMOVE THIS
INSTRUCTION PLATE
|
| Made in Canada |
|
|
| |||||||||||||||||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
16 | Regency |