Martin Fireplaces BV4536, BV5142 operating instructions Lighting Instructions Electronic IGN

Page 27

OPERATING INSTRUCTIONS

LIGHTING INSTRUCTIONS

ELECTRONIC IGN

1.STOP! Read the safety information below on this label.

2.Set the switch to “OFF”

3.Turn off all electric power to the appliance.

4.This appliance is equipped with an ignition device which automatically lights the burner. Do not try to light the burner by hand.

5.Wait five (5) minutes to clear out any gas. Than smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information below on this label. If you don’t smell gas, go to the next step.

6.Turn on all electric power to appliance.

7.Turn RS-OFF-ON rocker switch to “ON”

8.If the appliance will not operate, follow the instructions “To turn Off Gas To Appliance” and call you service technician or gas supplier.

Electronic Gas Valve

TO TURN OFF GAS TO APPLIANCE

1.Turn RS-OFF-ON rocker switch to “OFF”.

2.Turn off all electric power to the appliance if service is to be performed

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these Instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A. This appliance is equipped with an ignition device which automatically lights the pilot. Do not try to light the burner by hand.

B. BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

*Do not try to light any appliance

*Do not touch any electric switch; do not use any phone in your building.

*Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier’s instructions.

**If you cannot reach your gas supplier, call the fire department.

C. Turn off all electric power to appliance.

D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

26

Image 27
Contents Super B-VENT GAS Fireplace Table of Contents Important Safety Information Important Safety InformationAlways Burn Propane Models with Doors Closed Model LAB Type Certification Standard Product SPECIFICATIONS/LISTING & Code ApprovalProduct Specifications Listing & Code ApprovalPRE-INSTALLATION Information PRE-INSTALLATION InformationFireplace Dimensions PRE-INSTALLATION Information Combustible Clearances Mantel Clearance Floor Clearances Mantel ClearancesPRE-INSTALLATION Information Dim Min Max Feet Vent InstallationVent Installation Vertical Venting Straight up No ElbowInstalling Vent Components Piping InstallationsVertical Venting with Two 2 45 Degree Elbow To Locate and Install Ceiling Firestop For Vertical Termination Ceiling Firestop Location Vent TerminationOutside Air Kit Installation To Locate and install Vertical TerminationDo not use open flame to check for gas leaks GAS Line and ElectricalRemote Wall Switch Standing Pilot Ignition Wiring-Millivolt ControlComplete Millivolt System Check Millivolt Control Valve ChecklistOptional DC Remote Systems Thermopile Output CheckWiring Diagram for Electronic Ignition System Electronic Pilot Ignition WiringGAS Line and Electrical Installation Definitions Final InstallationLog Placement Log Placement for fiber VDY24/18D3RDoor Rail Installation Damper Operation Hi Temperature Cut Off Disc You may notice the following Operating InstructionsBefore Lighting the Fireplace Lighting the FireplaceLighting Instructions Millivolt Control Lighting Instructions Electronic IGN Burner Flame MaintenanceMaintenance Standing-Pilot Flame OnlySoot cleaning fluid may be used on refractory logs Vent SystemGlass Door Parts List / Illustration Parts List / IllustrationsConversion Kit Not Shown for MillivolControl Only Conversion Kit Not Shown for Electronic Ignition Page Electronic Ignition General Troubleshooting 41D2001 Rev 3 Dec Limited Lifetime Warranty Policy