Martin Fireplaces BV4536, BV5142 operating instructions Final Installation, Definitions

Page 21

FINAL INSTALLATION

FINAL INSTALLATION

Wall Finishing:

Definitions:

Combustible Materials - Materials made of or surfaced with wood, compressed paper, plant fibers, or other materials that are capable of being ignited and burned. Such materials are considered combustible even though flameproof, fire retardant, treated, or plastered.

Non-Combustible Materials - Materials which will not ignite and burn. Such materials are those consisting entirely of steel, iron brick, tile, concrete, slate, glass, marble, or combination thereof, or have a UL Fire rating of Zero (0).

High Temperature Sealant Material - Sealant that will withstand high temperature; General Electric RTV103 or equivalent.

Finishing the fireplace flush with a wall:

When finishing the face of the fireplace, combustible material may be brought up to the side or top edge of the fireplace, but must never overlap the black metal face. The black metal face may be covered with non-combustible material only. After applying the finishing material, a non-combustible sealant, 1/8” minimum, should be used to close off any gaps at the top and sides between the fireplace and the finishing to prevent cold air leaks. Refer to Figure 5: Finishing Material section in this manual for allowable locations for combustible materials.

Rock Wool Placement:

Rock wool should be evenly covering the burner from front to back. The rock wool should be separated into chunks about the size of a nickel. The bag supplied has an excess of rock wool. The remaining may be used as filler over time.

Lava Rock Placement:

Sprinkle a thin layer of lava rock on the floor of the inner chamber. DO NOT pile up in any area. It should be placed in a single layer only around but not on any portion of the burner.

WARNING

Do not sprinkle the lava rock on top of the burner. This may cause potential sooting, glass breakage and/or a

fire hazard

20

Image 21
Contents Super B-VENT GAS Fireplace Table of Contents Important Safety Information Important Safety InformationAlways Burn Propane Models with Doors Closed Product Specifications Product SPECIFICATIONS/LISTING & Code ApprovalListing & Code Approval Model LAB Type Certification StandardPRE-INSTALLATION Information PRE-INSTALLATION InformationFireplace Dimensions PRE-INSTALLATION Information Combustible Clearances Mantel Clearance Floor Clearances Mantel ClearancesPRE-INSTALLATION Information Vent Installation Vent InstallationVertical Venting Straight up No Elbow Dim Min Max FeetInstalling Vent Components Piping InstallationsVertical Venting with Two 2 45 Degree Elbow To Locate and Install Ceiling Firestop For Vertical Termination Ceiling Firestop Location Vent TerminationOutside Air Kit Installation To Locate and install Vertical TerminationDo not use open flame to check for gas leaks GAS Line and ElectricalRemote Wall Switch Standing Pilot Ignition Wiring-Millivolt ControlOptional DC Remote Systems Millivolt Control Valve ChecklistThermopile Output Check Complete Millivolt System CheckWiring Diagram for Electronic Ignition System Electronic Pilot Ignition WiringGAS Line and Electrical Installation Definitions Final InstallationLog Placement Log Placement for fiber VDY24/18D3RDoor Rail Installation Damper Operation Hi Temperature Cut Off Disc Before Lighting the Fireplace Operating InstructionsLighting the Fireplace You may notice the followingLighting Instructions Millivolt Control Lighting Instructions Electronic IGN Maintenance MaintenanceStanding-Pilot Flame Only Burner FlameSoot cleaning fluid may be used on refractory logs Vent SystemGlass Door Parts List / Illustration Parts List / IllustrationsConversion Kit Not Shown for MillivolControl Only Conversion Kit Not Shown for Electronic Ignition Page Electronic Ignition General Troubleshooting 41D2001 Rev 3 Dec Limited Lifetime Warranty Policy