INSTALLATION
FACEPLATE & TRIM
INSTALLATION
1)Lay the faceplate panels flat, face down on something soft so they don't scratch.
2)Take the top faceplate and align the holes in it with the holes in the side panels. Using the screws provided, attach from the top of the panel (the holes in the top panel are slightly larger than the holes in the side panel to facilitate easier installation). See diagram 1.
Diagram 1
Hint: Don't tighten the trim to the bottom of the faceplate side panels with the screws provided. See diagram 1.
3)Using the connectors provided, join the left side trim (with the ON/OFF switch) to the top trim. Connect the right side trim to the top trim.See diagram 2.
Diagram 2
Rear View: Trim Assembly
4)Place the trim on the assembled faceplate panels, aligning the wire connections from the switches with the notch on the left side panel.
5)Hookup the 3 Fan Switch wires to the fan switch on the left side trim. Diagram 3.
WARNING: The 3 wires are to the Fan and the 2 wires are to the ON/ OFF burner switch. DO NOT con- nect to the wrong switch.
Diagram 3
WARNING:
Ensure that the wires do NOT
touch the firebox
6)Connect the 2 burner ON/OFF switch wires by taking the yellow and orange wires with the female ends and connecting them to the burner ON/OFF switch.
7)Tuck the wires into the faceplate to keep them away from the inbuilt fireplace using the clip provided. Attach the clip to the rear of the faceplate to ensure that the wires do not touch the side of the unit. See diagram 3.
8)The power cord should be run behind the faceplate panel.
9)Attach the brass trim to the faceplate by drilling a 1/8" hole through into the faceplate using the hole in the trim as a guide. Fasten the trim to the faceplate panels using the plated screws. See diagram 4.
10)Attach the faceplate panels* to the inbuilt fireplace body using the 4 remaining black screws. See diagram 5.
11)Push the Regency logo plate into the two holes in the bottom left corner of the face- plate. See diagram 4.
Diagram 4
Diagram 5
FLUSH FRONT
INSTALLATION
1)Install Logs before going on to the next step. See the Log Installation instruction sheet or page 8 in the manual.
2)Install the bottom glass trim by hooking the trim into the lip on the firebox base. The trim will not fit into place if the glass is installed first.
10 | Regency |