Regency I31-LPG3, I31-NG3 Pins on Rear Log Support, PinCutout, Notch Cutout, Bracket

INSTALLATION

A)02-43

Pins on Rear Log Support

4)Place Front Right Log B)02-45 on the two pins as shown.

D)02-46

A)02-43

C)02-56

PinCutout

7)Place the notch in Center Log E)02-47 over Log B)02-45 and across the cutout on Log A)02-43.

		A)02-43
45	F)02-48
B)02-
	Side View
	Bracket	Front edge of
		rear burner

The bottom right edge of Log F)02-48 must sit snugly against the bracket and the front edge of the rear burner.

9) Place Front Left Log G)02-44 onto the 2 front pins as shown.

B)02-45

5)Place the Middle Left Log C)02-56 on the two pins as shown.

C)02-56

E)02-47 A)02-43

B)02-45

Notch Cutout

G)02-44

10)Place the embers and Rockwool on the exposed front burner tray.

Logs D)02-46 and E)02-47 in position.
8) Position notch in Front Right Log F)02-48 on	11) Test fire to ensure proper light off (make
Log E)02-47 and push the bottom right edge
against the bracket on the burner tray and	sure flame flows smoothly from one end of
the front edge of the rear burner.	burner to the other. If there is any flame
	hesitation, check that area for any blockage
	of the burner port.
F)02-48	12) Install flush glass and optional bay glass as
	per instructions in this manual.

Logs A)02-43, C)02-56, and

B)02-45 in position

6)Place the Left Top Log D)02-46 on the pin on Log C)02-56 and on top of the cutout on Log A)02-43.

E)02 - 47

Notch

B)02-45

Bracket

-46	C)02-56
D)02

G)02-44

47 - E)02

F)02	A)02-43
-
	48
	B)02-45

Regency I31-3 Gas Fireplace Inbuilt 9