INSTALLATION
3)Place the bottom of the flush glass behind the bottom glass trim.
4)Secure the glass with the two glass clips at the top corners of the glass. Secure glass clips with the screws provided. Do not over tighten as this could break the glass.
5)Slide in the top glass trim under the spring clips.
6)Install safety screen (only in Australia) by inserting the 4 brackets into the 4 slots.
Note: Top and bottom louvres and brack- ets are different.
2)The bottom louvre has a hinge that is attached (2 screws per hinge) to the lip on bottom of the unit.
BAY FRONT
INSTALLATION
1)Place the bay door onto the 2 pins on the top of the unit.
2)Position 2 magnets on the back of each trim piece close to the ends. Place the top and bottom trim pieces on the bay front.
BAY LOUVRES
1)Install top louvre by sliding the two bracket clips into the brackets located on top of the bay door. See below. The fitted louvre leaves a small gap between faceplate bot- tom and louvre top.
2)Install bottom louvre by sliding the two bracket clips into the brackets located un- derneath the bay door and secure with 2 screws into the bracket on the bottom of the Bay Front as per diagram above.
3)Slide the valve extension knobs onto the valve knobs. match the correct ext. knob with the valve knob.
Note: Optional safety screen only in
Australia.
FLUSH LOUVRES
1) The top louvre is held in place by friction fit, | Note: The top and | ||
if the louvre needs to be adjusted; bend the | bottom | trim piec- | |
bracket out as shown in the diagram. | es are | different, | |
|
| check | diagrams |
|
| above and below. | |
|
| ||
3) Install top and bottom louvres.
Regency | 11 |