Installation / Assembly
Installing Side Burners
1.Assemble a 9.5 mm pipe nipple to the 9.5 mm pipe tee using Teflon tape or pipe sealant. Use only sealant that is approved for use on LP gas.
2.Install the pipe tee assembly to the grill intake pipe. Tighten assembly and align the branch opening of the tee with the hole of the cabinet.
3.Connect the flexible hose (male end) to the pipe tee.
4.Install and secure the side burner into the island by simply setting it in place.
5.Connect the female end of the flexible hose to the side burner intake pipe.
6.Connect gas supply to the grill.
7.Check for gas leaks using soap water solution.
Items included with barbecue
1)One 9.5 mm "T" adapter
2)Two 9.5 mm hose fittings
Regulator is NOT included with barbecue.
AOpen barbecue door. Install flexible hose with regulator to gas source, then connect other end to "T" adapter.
Make sure to use gas rated tape seal when installing adapter to insure proper seal.
"T" Adapter (9.5 mm threaded)
To grill, located | To side burner, located |
underneath and | |
behind grill | underneath behind burner. |
From Grill | From Side Burner |
| |
9.5 mm fittings | To gas source |
NOTE: You will need to use a gas rated
sealer on gas connectors that are not flared.
C
Grill B
A
BTake the other end of "T" adapter with flexible hose attached and connect to end of male fitting located underneath and at the back of the grill. (Use gas rated tape seal on all connections).
CConnect the last open line to the side burner. (Use gas rated tape seal on all connections)
Page 8 | Cal Flame 2008 Owner’s Manual |
LTR20081044, Rev. A