Appendix
Removing and Replacing Infrared Burners
1.Disconnect or shut off the gas line connect to the grill. Wait until the burners cool down.
2.Open the hood and remove the grate and flame tamer on top of the burner you want to replace.
3.Through the access door underneath the grill, find the round stud and locking pin that locks the burner you want to replace.
4.Carefully remove the locking pin with your fingers.
5.Raise the stud from the locking hole and move the burner forward carefully to release it from the igni- tion and gas supply valve.
6.Take the burner out of the grill and store it in a safe and dry place.
7.Install the infrared burner. Align the gas inlet on the burner with the gas supply valve on the grill and torch tube with ignition. Make sure they align per- fectly. Slide the stud at the other end into the locking hole.
8.Adjust the infrared burner. Make sure the burner is aligned and in position.
9.Install the locking pin. Through the access door un- derneath the grill, find the stud to lock the burner in place. Install the locking pin. Make sure the locking pin is secured correctly.
10.Repeat steps 2 through 9 if you want to replace oth- er burners.
11.Put back the grate you just removed. (You don’t need the flame tamer for infrared burners.)
12.Reconnect or turn on the gas line.
If you want to change back to regular burners, just follow the procedure above in reverse order.
Replacement Covers
2 burner / 3 burner grill | CVRBLT001 | 5 burner with deluxe 2 side burner | CVRCRT036 |
4 burner grill | CVRBLT003 | Standard single flat side burner | CVRSBR050 |
5 burner grill | CVRBLT007 | Standard side by side flat burner | CVRSBR052 |
2 burner / 3 burner cart | CVRCRT030 | Deluxe double side burner | CVRSBR054 |
4 burner cart | CVRCRT032 | Deluxe double side by side burner | CVRSBR056 |
Cal Flame 2008 Owner’s Manual | Page 17 |
LTR20081044, Rev. A