Cal Flame LTR20081044 manual Problem Plugged orifice, Problem Misalignment of Igniter on Burner

Page 18

Appendix

Problem: Plugged orifice

Solution: Unplug the orifice as follows:

Remove cooking grills, flame tamer and grease tray.

Remove burners from the bottom of the firebox by pulling the cotter pin from beneath the burner peg using a standard screwdriver or needle nose pliers.

Carefully lift each burner up and away from the gas orifice.

Remove the orifice from the control valve.

Gently clear any obstruction with a fine wire.

Reinstall the orifice, reinstall the burners over the orifices, and seat each burner peg into position hole at the bottom ledge of the firebox.

Replace all cotter pins.

Replace cooking components and grease collectors.

If an obstruction is suspected in the control valve, contact your local Cal Flame dealer for assis- tance.

Problem: Misalignment of Igniter on Burner

Solution: • Check for proper position of the electrode tip, which should be pointing forward towards the front of the burner and free of grease to allow proper sparking.

The ignition wire should be connected firmly to the valve ignition device and electrode. Replace the ignition wire if it is frayed or cracked.

With the gas supply closed and all control knobs set to the off position, check each position igniter individually for the presence of a spark at the electrode. Push each knob in fully and rotate it about 1/4 turn to the left (counter-clockwise) until you hear a loud click. The trigger hitting the strike block should produce a blue spark at the electrode tip. Return control knob to the off position before checking the next igniter.

While the grill is still hot, wait for a minimum of five minutes before commencing re-ignition. (This allows accumulated gas fumes to clear.) If all checks / corrections have been made and the gas grill still fails to operate properly, contact your local Cal Flame dealer.

Problem: Flashback

Solution: When fire occurs in and around the burner tubes, immediately turn off gas at its source and turn the control knob clockwise to the ‘OFF’ position. Wait until the grill has cooled off and then clean the burner tubes and burners as described on page of this manual.

Page 16

Cal Flame 2008 Owner’s Manual

LTR20081044, Rev. A

Image 18
Contents LTR20081044, Rev. a 4/21/08 Operating Your Barbecue Safety Instructions Installation / AssemblyCleaning and Maintenance AppendixOperation Safety InstructionsPlacement and Location Set-UpMaintenance and Repair Precautions Regarding ChildrenStorage Installation / Assembly Cabinet Cut-out DimensionsTank Requirements Leak Testing ProcedureLiquid Propane Gas Model Number Description Width Depth HeightInstalling the Transformer LP Gas Hook UpTransporting and Storing LP Gas Installing Grills in Barbecue Islands Installing the Rotisserie Installing Side Burners Operating Your Barbecue Grill ControlsLighting the Grill Electronically Lighting the Grill and Infra- red BurnersManually Lighting the Grill and Infrared Burners Basic Grill Operation Cooking with the RotisserieLight and Fan Switch Cooking with a Side BurnerCooking with a Convection Grill Cleaning and Maintenance Light Bulb Replacement Light ReplacementLight Removal AppendixTroubleshooting Problem Plugged orifice Problem Misalignment of Igniter on BurnerProblem Flashback Replacement Covers Removing and Replacing Infrared BurnersCountry of destination Grill SpecificationsLocation of Serial Number Plate Gas category