Stainless Steel Optimum Console Assembly Instructions

Mountings

Stainless Steel Optimum Console

Assembly Instructions

•The JNR, WNK or TJK model grills may be mounted on the Optimum Console.

•The gas supply may be either LP or Natural.

•The grill head should not be attached to the Optimum Console until the console is completely assembled

•The Optimum Console comes in two car- tons—Box A contains the console and all associated hardware. Box B contains either the pedestal or cart base and all base hardware.

Please check to be sure that all parts are included before proceeding. Contact your dealer if any parts are missing.

Step 1: Connect the Tank Locking Bar (Fig. 10)

1.From box “A” locate and attach the Tank Lock Bar across the back of the pedestal column. Use the ¾" S.S. Hex bolt, Nylon Lock Bar Spacer and a Kep nut on each side to fasten the Tank Lock Bar in place. This spreads and holds the correct spacing at the back of the column.

Parts	Quantity
BOX A
Stainless Steel Front Panel	1
Stainless Steel Console	1
Stainless Grease Cup	1
Tank Lock Bar	1
Hardware Kit
Nylon Lock Bar Spacers	2
¼ - 20x1¼" S.S. Hex Head Bolts	4
¼ - 20 S.S. KEP Nuts	12
¼ S. S. Washers	10
¼ - 20 x ¾" S.S. Hex Bolts	8
Rectangular Washers	4
2-piece Gasket	1
BOX B
Cast Aluminum Base	1
12’ Nat. Gas Hose/Quick Discount	1 (Cart Nat.
	Gas Only)
Stainless Steel Flexible Tubing, 28”	1 (Pedestal Nat.
	Gas Only)
Axle	1 (Cart Only)
Axle Clips	2 (Cart Only)
6 " Wheels	2 (Cart Only)
Hub Caps	2 (Cart Only)

Note: While assembling, peel the thin white protective film covering the stainless steel surfaces, especially in areas which will be partially hidden after assembled. Do Not

Scrape off.

Step 2: Attach the Base to the Pedestal (Fig. 11)

1.Before bolting the pedestal column to the base, the 2-piece gasket must be installed to create a barrier between the two metals. Remove the backing strips from the gasket to expose the adhesive and stick the gasket to the bottom lip of the pedestal column.

Make sure to align the holes.

2.Attaching the pedestal column to the base will be easier to handle by laying the pedestal column face down and matching the holes on the pedestal col- umn lip to the holes on the base. Use six ¾” bolts, four large rectangular washers, and on the under- side six round washers and KEP nuts. IMPORTANT: the large rectangular washers are used at the sides on top of the pedestal column lip. The round washers and KEP nuts are used under the base. Tighten securely and stand unit upright.

Mountings