Mountings
Built-in Kit Mounting
Assembly Instructions (NMS)
•The JNR, WNK or TJK model grills may be mounted as a
•For use with natural or
•Use of the
•Enclosure must be constructed from non com- bustible materials.
•The
•Refer to appropriate section for grill head as- sembly.
Please check to be sure that all parts are included be- fore proceeding. Contact your dealer if any parts are missing.
Parts | Quantity |
Set of doors with magnetic catches |
|
Consisting of: |
|
Frame for Door Set | 1 |
Left Hand Door | 1 |
Right Hand Door | 1 |
Heat Shield | 1 |
Magnetic Catches | 2 |
Door Handles | 2 |
Front Face Plate for NMS (26" W x 11" H x 1½" D) 1 | |
Right Side “L” Bracket 19" x 11" | 1 |
Left Side “L” Bracket 19" x 11" | 1 |
Rear Support Bracket 26 1/8" long | 1 |
Grease Tray | 1 |
Hardware Kit |
|
¼ - 20 x ¾" Hex lts | 12 |
¼ - 20 x 1 ¼" Hex Bolts | 4 |
¼" Nuts | 4 |
¼" Flat Washers | 4 |
¼" Lock Washers | 16 |
|
|
Important Notes:
Your structure should have a 3" to 4" concrete base on a sand footing.
The panel doors must have a 4" to 6" minimum elevation from the ground.
If your structure includes a back splash, allow 11" to the back edge of grill opening to allow the lid to open com- pletely.
Combustible material should never be within 24 inches of the top, bottom, back or sides of your Grill.
Complete View Of Built-In
Step 1: Required Dimensions For Built-In
(Fig. 16)
1.The grill head fits into an opening of 27½" wide by 10¾" high by 18" deep.
2.The Panel doors fit into an opening of 27¼" wide by 16¾" tall.
3.The side burner fits a surface opening of 10¼" wide
by 11¾" front to back. It should be at least 5" away from the grill opening.
(The front face flanges on the mounting and the panel doors overlap the required opening surfaces by 15/8" and provide a clean look.)
12