Mountings
Step 1: Patio Base Mounting Assembly (Fig. 5)
1.Turn base on edge and insert the 2’ post. Align the notches in the post with the notches in the base. IM- PORTANT: Close tolerances may require you to tap the top of the post to seat it completely in the base socket which will then align the bolt slots.
2.Fasten post to base with four ¼ - 20 x ¾" Hex bolts, washers and Kep nuts. Follow exact placement of washers as indicated. Tighten securely.
3.Attach the tube clip with the 8 - 32
Step 2: Deck/Patio Mounting Installation
(Fig. 6)
Position the patio base at the desired location on a deck or patio. CAUTION: Be certain there are no combustible materials above, behind, left or right closer than 24" away.
1.Mark the location of the four holes at the outside corners of the patio base and drill four holes. The base will be fastened down with lag bolts (not sup- plied by MHP) after you have connected the gas supply line. The top post notch is the front and the rear access door will be in the back of the grill.
2.Run the gas supply line into the post from the bot- tom to reach the access door and bend it 90° to exit the base at either notch. The patio base is notched on two sides to allow the gas line to exit either right or left.
8
3.Secure the gas line with the tube clip. (Option: On a raised deck if the gas supply line is to be run straight up into the post from below use the tube clip to attach the gas line to the deck for support.
4.At the access door connect a 3/8" flare coupling (not supplied by MHP) to the gas supply line and Stainless Steel tubing. Position the tubing in the top notch of the post. Bend the tubing at the top end to match the Feed Line of the grill valve. Do not kink the tubing.
TUBE BENDING: For proper bending of the stainless steel tubing, see page 26 for bending instructions.
Step 3: Attaching The Grill Head Bottom To The Deck/Patio Post (Fig. 7 & Fig. 8)
1.To make the
2.Set the grill head bottom carefully in place, align holes and use the ¼ - 20 x ¾" bolts and