MHP WNK, TJK, JNR Mountings, Cart Assembly Instructions JCP, JCN, WCP & WCN, Leg Assembly Fig

Mountings

Cart Assembly Instructions (JCP, JCN, WCP & WCN)

Cart Mounting carton contains the following components:

Please check to be sure that all parts are included be- fore proceeding. Contact your dealer if any parts are missing.

Parts	Quantity
Long Legs	2
Short Legs	2
Lower Shelf Frame	1
Stainless Grease Cup	1
Grease Cup Holder	1
8” Rubber Wheels	2
Axle Hitch Pins	2
Axle Washers	2
Hub Caps	2
Hose Retaining Ring	1
LP Tank Holder Ring Assembly	1	(Propane Models Only)
Hardware Kit
¼-20 x 1 ½" Rd. Hd. Sltd. Bolts	11
¼-20 Kep Nuts	15
10-24 x ½" Rd. Hd. Sltd. Bolt	1
10-24 x ½" Hex Kep Nut	1
¼-20 Thumb Sc	1	(Propane Cart Only)
¼-20 x ¾" Hex Head Bolt	1 (Propane Cart Only)
12’ Natural Gas Hose	1 (Nat. Gas Cart Only)
Brass Quick-Disconnect	1	(Nat. Gas Cart Only)
Quick-Disconnect Dust Plug	1	(Nat. Gas Cart Only)
Dust Cap	1	(Nat. Gas Cart Only)

Step 1: Leg Assembly (Fig. 2)

1.Tip the grill head bottom on end as shown in Fig. 2. (TIP: work on protected area such as: carpet, tarp or one of the boxes to protect cart finish.)

2.Attach the two short legs to the left end of the grill head bottom with the “Hose Ring Hole” leg facing grill front. Use two ¼-20 x 1½" slotted bolts for each leg. Insert bolts from inside grill box, attach leg and fasten with ¼-20 Kep nuts.

3.Attach the two long legs to the right end of the grill head bottom. Use two ¼-20 x 1½" slotted bolts for each leg. Insert bolts from inside grill box, attach leg and fasten with ¼-20 Kep nuts.

4.Attached the hose clamp ring to the front left short leg with the 10 x 24 x ½" Rd. Hd. slotted bolt.

FINGER TIGHTEN ALL BOLTS UNTIL

LOWER SHELF IS ATTACHED.

Complete view of Cart Assembly	Step 2: Lower Shelf Assembly (Fig. 3)
	1.	Slip the lower shelf axle through the holes in the
		short legs.
	2.	Slide the wheels on the axle ends, then a washer
		on each, followed by a hitch pin clip through the
		axle hole. Tap plastic hub cap lightly to secure
		tight.
	3.	Align the other end of the lower shelf with the holes
		in the long legs. For the JNR model, slip the axle
		through the holes and fasten both ends with the
		threaded ¼-20 x ¾" slotted Rd. Hd. head bolt. For
		WNK model, use two ¼-20 x 1½" bolts and Kep
		nuts to fasten the lower shelf to the long legs (see
		Fig 3 inset).

STAND GRILL UPRIGHT TO SEAT LEGS AND

TIGHTEN ALL BOLTS AND NUTS MAKING THE LEGS &

FRAME RIGID. PERIODICALLY CHECK ALL

FASTENERS FOR TIGHTNESS.

6