OWNER’S MANUAL
FIREPLACE INSTALLATION
Continued
INSTALLING OPTIONAL BRICK LINER D8037A
WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before installing brick liner.
This brick liner kit is optional. You may purchase brick liner from your local dealer or see Accessories, pages 34 and 35.
CAUTION: Always handle brick panels with two hands. Do not force brick panels into place. Excessive force will break brick panels.
1.Remove glass door. See Removing/Re- placing Glass Door, page 22.
2.If installing brick liner in new fireplace, go to step 3. If installing brick liner in an existing fireplace, carefully remove logs, lava rock, and ember material.
3.Install left side brick panel first by slid- ing it between the grate and the side of the firebox (see Figure 48).
4.Slide the left retainer bracket against the left side brick panel. Loosely se- cure the bracket screw. This secures the left side brick panel.
5.Install the right brick panel using the same method described in step 3.
6.Slide the right retainer bracket against the right side brick panel. Loosely se- cure the bracket screw. This secures the right side brick panel.
7.Install rear brick panel. Rest bottom edge of panel on back edge of grate (see Figure 49).
8.Loosely secure retainer brackets to grate. Brackets are adjustable left to right to allow proper placement of panel. These will hold rear panel in place.
9.Tighten all bracket screws.
10.Follow instructions on page 24 to install logs, lava rock, and ember material.
11.Replace glass door (see page 22).
Left Side
Brick Panel
Figure 48 - Installing Left Side Brick Panel
Rear Brick Panel
Retaining Brackets
Figure 49 - Installing Rear Brick Panel and Retainer Brackets
Continued
106516 | 23 |