Desa (V)T32EP-A SERIES, (V)T32EN-A SERIES Removing/Replacing Glass Door, Removing Louver Panels

Page 22

Fireplace

Installation

Continued

Test Pressures Equal To or Less Than

1/2 PSIG (3.5 kPa)

1. Close equipment shutoff valve (see Figure 33).

2. Pressurize supply piping system by either opening propane/LP supply tank valve for propane/LP gas fireplace or opening main gas valve located on or near gas meter for natural gas fireplace or using compressed air.

3. Check all joints from propane/LP supply tank for propane/LP or gas meter for natural gas to equipment shutoff valve (see Figure 34 or Figure 35). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all leaks at once.

EquipmentOpen

Shutoff

Valve

Closed

Figure 33 - Equipment Shutoff Valve

Equipment

Shutoff Valve

Propane/LP

Supply Tank

Gas Valve

Figure 34 - Checking Gas Joints for

Propane/LP Gas Fireplace

Equipment

Shutoff

Valve

Gas

Meter

Gas Valve

Figure 35 - Checking Gas Joints for

Natural Gas Fireplace

Pressure Testing Fireplace Gas

Connections

1. Open equipment shutoff valve (see Figure 33).

2. Open propane/LP supply tank valve for propane/LP fireplace or main gas valve located on or near gas meter for natural gas fireplace.

3. Make sure control knob of fireplace is in the OFF position.

4. Check all joints from equipment shutoff valve to gas valve (see Figure 34 or Figure 35). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all leaks at once.

5. Light fireplace (see Operating Fireplace, page

23). Check all other internal joints for leaks.

6. Turn off fireplace (see To Turn Off Gas to Appli- ance, page 24).

Removing/Replacing Glass

Door

CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For replacement part informa- tion see Replacement Parts, page 32.

CAUTION: Wear gloves and safety glasses while handling or removingbrokenglass.Donotre- moveifglassishot.Keepchildren and pets away from glass.

WARNING: If fireplace has been running, turn off and un- plug fireplace. Let cool before re- moving glass door or louvers.

Removing Louver Panels

Remove the top and bottom louver panels by si- multaneously pulling both top end spring latches towards the center of the appliance until they are disengaged from the locating holes (see Figure 36, page 23). Repeat for bottom spring latches and pull the louvers outward. To install or replace items removed, simply reverse the procedures above.

22

www.desatech.com

116647-01B

Image 22
Contents What to do if YOU Smell GAS Table of Contents Safety InformationSafety Information Product Identification Product FeaturesLocal Codes Clearances Pre-Installation PreparationLocation and space requirements Flush with a wallFraming and finishing Location of Termination Cap Termination CAP AIR Supply Inlet GAS MeterVenting Installation Instructions Installation PrecautionsCenter Installation PlanningMale Slots Female Locking Lugs HoleVent Cap Wood Screw Noncombustible ExteriorSquare Termination Venting InstallationHorizontal H 53 3/4 min Wall Firestop Elbow43 3/4 min None 65 3/4 minVertical V Horizontal H Venting with Two 90 ElbowsMin Max 12 max 18 max 20 max Elbow Min Max 12 max 18 max Elbow 20 maxRoof Flashing Wall Strap Elbow Ceiling Firestop Installation for vertical terminationFlat Ceiling Installation If area above is aVenting with One 90 Elbow Vertical V Horizontal H Min Max 20 max ElbowMin Max 12 max 18 max 20 max Vertical Venting High Altitude InstallationParts list for venting kits and components = 40 max ElbowModel BK Installation Fireplace InstallationInstalling optional blower accessory Check GAS TypeModel BKT Installation Wiring Diagram Decal 12 in Front BlowerRight outside Blower Wiring Diagram Blower Model BKTInstalling Gas Piping to Fireplace Location Installation Items NeededChecking GAS Connections Connecting Fireplace to GAS SupplyRed Surface Test Pressures Equal To or Less Than Psig 3.5 kPa Pressure Testing Fireplace Gas ConnectionsRemoving/Replacing Glass Door Removing Louver PanelsCleaning Glass Door Installing Optional Brick liner Model BL32DRemoving Glass Door Installing logs, lava rock and glowing embers Left Side Brick PanelWall Switch Installation Optional Remote control Installation model WRCOperating Fireplace Wiring DiagramFor Your Safety Read Before Lighting Lighting InstructionsTo Turn OFF GAS To Appliance Operating optional blower accessoryOptional Remote Operation Inspecting Burners Cleaning MaintenancePilot Assembly Burner Flame PatternLogs Pilot and burnersVenting system Troubleshooting Observed Problem Possible Cause RemedyGas leak. See Warning Checking Gas ConnectionsTechnical Service Replacement PartsService Hints SpecificationsAccessories Remote Control KIT WRCIllustrated Parts Breakdown 22-1 1141814123 21171 24353 24460 22-2109 Electronic Valve Propane/LP 116647-01B 116647-01B Keep this Warranty Warranty InformationLimited Warranty DIRECT-VENT Fireplace