OWNER’S MANUAL
FIREPLACE INSTALLATION
Continued
INSTALLING OPTIONAL WIRELESS
Installing Remote Receiver
1.Open bottom louver and locate the switch bracket on the left.
2.Unscrew the switch bracket. Lean bracket forward so you are able to ac- cess the back of the remote receiver.
3.Locate the battery clip mounted on the back of the receiver. Slide a
4.Attach the terminal wires to the battery.
5.Remove the wire that runs from TH to TPTH from the valve (see Figure 40).
6.Connect wires from reciever to TH and TPTH on the valve (see Figure 41).
7.Replace the switch bracket.
Figure 40 - Disconnecting TH to TPTH Wire
To Wall Optional
Remote Accessory
t
Figure 41 - Control Valve Terminals
Receiver
Terminal
Wires
Battery Clip
Figure 42 - Attaching Battery to Receiver
Installing 9-Volt Battery in Hand- Held Remote Control Unit
1.Remove battery cover on back of re- mote control unit.
2.Attach terminal wires to a
3.Replace battery cover onto remote con- trol unit.
| Battery |
|
Terminal | Cover | Remote |
| ||
Wires |
| Control Unit |
|
| |
Battery |
|
|
|
| Battery |
|
| Housing |
Figure 43 - Installing Battery in Hand- Held Remote Control Unit
REMOVING/REPLACING GLASS DOOR
You must remove glass door to install op- tional brick liners, logs, lava rock, and em- ber material.
CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For re- placement part information see Replacement Parts, page 30.
1.Remove the upper louver panel by lift- ing upward and out (see Figure 44).
2.Remove the screws from the three tabs at the top of the glass door while hold- ing door securely keeping it from fall- ing forward.
3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 45).
4.To replace glass door, follow the above instructions in reverse.
Top Louver
Panel
Figure 44 - Removing Top Louver Panel
Screw
Glass Door
Assembly
Lower Bracket for
Glass Door Assembly
Figure45 -Removing/ReplacingGlassDoor
Continued
105453 | 21 |