Hearth and Home Technologies Montana-42, Montana-36 Maintenance Instructions, Disposal of Ashes

Page 25

MONTANA INSTALLATION INSTRUCTIONS

H. MAINTENANCE INSTRUCTIONS

1.Disposal of Ashes

Ashes should be placed in a metal container with a tight-fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal. If the ashes are disposed of by burial in soil or otherwise locally dispersed, they should be retained in the closed container until all embers have thoroughly cooled.

2.Creosote and Soot

Inspect the chimney internally for obstructions and construction damage. Flue pipe joints and seams must be continuous and mechanical tight. In a used chimney, additional inspection is needed for creosote buildup, which is the formation of a flammable sediment.

When wood is burned slowly, it produces tar and other organic vapors, which combine with expelled moisture to form creosote. The creosote vapors condense in the relatively cool chimney flue of a slow-burning fire. As a result, creosote residue accumulates on the flue lining. When ignited, this creosote makes an extremely hot fire.

The chimney should be inspected at least twice a year during the heating season to determine if creosote buildup has occurred.

If creosote has accumulated, it should be removed to reduce the risk of a chimney fire.

3.Chimney Cleaning

If you do detect a buildup of creosote, contact a qualified chimney sweep or clean it yourself. To do this, perform the following steps:

a.Open the damper.

b.Hang a damp sheet across the fireplace opening to stop dirt and soot from entering the room.

c.Remove the termination cap or housing top. See Figure 25.

d.Clean with a stiff nylon brush attached to a pole OR tie a small burlap bag filled with straw and several small stones or sand. Work up and down the flue until the flue is clean.

e.Replace the termination cap or housing top.

WARNING!

A chimney fire can permanently damage your chimney system. This damage can only be repaired by replacing the damaged component parts. Chimney fires are not cov- ered by the Limited Warranty and Buyer Protection Plan.

4.Clear Space Near the Fireplace

Combustible materials must not be stored on the hearth extension. Room furnishings such as drapes, curtains, chairs, or other combustibles must be at least four feet from the open front of the fireplace.

Figure 25

Chimney & Termination Cap Cleaning

01/04

4039-150 Rev B

25

Image 25
Contents MONTANA-36 and MONTANA-42 Outdoor Woodburning Fireplace Installation & Operating InstructionsTable of Contents Description of the Fireplace System Listings and Code ApprovalsHeat-N-Glo fireplace system consists of the following Optional Components IncludeFireplace Components Fireplace System ComponentsCatalog # Description Chimney ComponentsFirestop Spacer TR11T Fireplace Locations and Space Requirements PRE-INSTALLATION PreparationFrame the Fireplace Construct an Outdoor EnclosureSidewalls/Surrounds Chimney Requirements Using Offsets and ReturnsNumber of Sections Required Chimney Height Requirements above roof linePosition the Fireplace Installation of the FireplacePlace the Protective Metal Hearth Strips Level the FireplaceAssemble Chimney Sections Install Firestop Spacers∅ 6. Attic Insulation Shield Double-check the Chimney AssemblySecure the Chimney System Installing a TR11T Round Telescoping Termination Cap Install the Termination CapInstall the Chimney Air Kit Install the Cooling Air Kit furnishedGas Log/Lighter Provisions Complete the EnclosureFactory Built Hearth Extension Hearth ExtensionFinishing Material Position the Hearth ExtensionMantel Glass DoorsMontana Installation Instructions General Information Flue Damper Operating InstructionsFirescreen GrateWood Fuel Starting a Fire Chimney Cleaning Maintenance InstructionsDisposal of Ashes Creosote and SootHomeowner’s Notes Index Warranty For HEAT-N-GLO Fireplaces