MONTANA INSTALLATION INSTRUCTIONS
A. LISTINGS AND CODE APPROVALS
This fireplace system has been tested and listed in accordance with UL 127 standards, and has been listed by Underwriters Laboratories Inc. for installation and operation in the United States as described in this manual.
This fireplace has been tested and listed for use with the optional components listed on page 4. These optional components may be purchased separately and installed at a later date. However, installation of a dual cooling air kit is required and must be installed at the time of the initial fireplace installation. Failure to do so may result in a fire causing property damage and/or personal injury.
Check with your local building code agency prior to installing this fireplace to ensure compliance with local codes, including the need for permits and
WARNING!
This fireplace and its components are designed to be installed and operated as a system. Any alteration to or substitution for items in this system, unless allowed by these installation instructions, will void the Underwriters Laboratories listing and may void the product warranty. It may also create a hazardous installation. Read through these instructions thoroughly before starting your installation and follow them carefully throughout your project.
B. DESCRIPTION OF THE FIREPLACE SYSTEM
1.The Heat-N-Glo fireplace system consists of the following:
a.Fireplace/Integral Grate/Cooling Air System
b.Refractory
c.Chimney Termination Cap
d.Chimney System
e.Hearth Extension
2.Optional Components Include:
a.Glass Doors
b.Weather Cover
Note: Illustrations used throughout these instructions reflect “typical installations” and are for design purposes only. Actual installation may vary slightly due to individual design prefer- ences. However, minimum and maximum clearances must be maintained at all times.
The illustrations and diagrams used throughout these installa- tions instructions are not drawn to scale.
Figure 1 - Typical Fireplace System
01/04 | 3 |