DCS BGB48, BGB36 installation instructions LPG Cylinder Restraint for BUILT-IN Installation, Max

INSTALLATION

GAS HOOK-UP

LPG CYLINDER RESTRAINT FOR BUILT-IN INSTALLATION

If the grill is to be installed in a Built-in application, then the grill must be installed in accordance with the Built–in installation guidelines.

If you intend to operate your Built-in grill on LPG gas utilizing a minimum 9 kg cylinder, then the Built-in LPG cyl- inder restraint must be installed prior to initial use of the grill. If you do not have one please contact DCS by Fisher & Paykel for information on obtaining one. See section ‘Service’ for contact details.

The following steps will illustrate how to properly locate and install the LPG cylinder restraint within the Built-in enclosure.

NOTE:

The grill comes with the LPG Regulator/Hose assembly installed at the factory. The assembly, along with the entire grill system, is leak tested.

Do not remove the Regulator/Hose assembly from the grill during installation.

The maximum distance from the centre of the manifold cut out to the centre of the cylinder restraint is 457 mm.

457mm

max.

Centre of Cylinder Restraint must be placed within this area to avoid causing stress on the LPG regulator hose connection.

Centre of manifold cut out projected to floor of the island.

FIG. 13

16