Coleman 9992-449 system manual You are now ready to install New LP manifold

Page 6

Liquid Propane Gas Conversion Instructions

You are now ready to install

the new LP manifold.

16.NOTE: New screws for the bezels are inserted into the new LP manifold at the factory. Remove them before proceeding with Step 17.

17.Place the new manifold into the grill body with the control knob stems going outward through control panel front (Fig. 15).

18.Reattach the bezels to the manifold with the screws. Make sure that "off" is facing up on the bezel (Fig. 12 & 13).

19.Reattach the control knobs onto the manifold stems, making sure the arrow is facing upwards (Fig. 11).

20.Reattach the flexline on the left of the grill to the back infrared valve using an adjustable wrench (Fig. 10).

21.Reattach the flexline on the right of the grill to the new manifold using the adjustable wrench (Fig. 9).

22.Reinstall burners into the grill body. Line up the burners with the valves on the manifold, making sure they are level. Make sure the burners are fully over the valves (Fig. 16).

23.Reattach the igniters and their heat shields (removed in Steps 2, 3, and 4) to the burners (Fig. 2, 3, and 4).

24.Reattach the rear heat shields before attaching the front heat shield to be sure the burners remain over the valves (Fig. 2).

25.Reinstall the front heat shield (Fig. 5, 6, and 7).

26.Reinstall the heat tents (Fig. 1).

27.Reinstall the cooking grates.

Control Knob

Stems

Fig 15

Valves

Burners

Fig 16

6

Image 6
Contents Liquid Propane Conversion Kit Liquid Propane Gas Conversion Instructions Tools Needed Screws Under lip Flex Line Gas Inlet Flex Line Manifold Screws You are now ready to install New LP manifold Installing the L.P. regulator Pipe dope should not be used on any flared fittingsConverting the Rear Infrared Burner to LP Installation is now complete Enjoy your grill safely Label the GrillLiquid Propane Gas Conversion Instructions Liquid Propane Gas Conversion Instructions 9992-449 8/14/06