5.Place the Tank
Head Screws provided. See Fig. 4. Slide tray back into Bracket.
6.Before installing the Door Bracket to the inside of front Cart Side Panels be sure Door
Stops for Magnets on the Door Bracket are located on the front side. See Fig. 5.
Figure 4 (LP gas model only)
CART SIDE
PANEL*LEFTREAR
PANEL
TANK
TRAY KIT
(LP gas model only)
7.Install the Door Bracket to the inside of front
Cart Side Panels. Align the threaded holes on the Door Bracket with the holes on Cart Side
Panels. Tighten securely by using 4 of the
l/4"x50mm Phillips Head Screws provided. See Fig. 5.
8.Remove the white protective film from the stainless steel Decorative Panel.
g.Install the Decorative Panel to the Cart. Align the 2 threaded holes on the bottom of Door
Bracket and the 2 threaded holes on the top of Bottom Shelf with the 4 holes on the
Decorative Inside Plate. Tighten securely by using 4 of the 1/4"xl/2" Phillips Head Screws provided. Then Tighten 4 loose screws on the Door Bracket. See Fig. 6
10.Install the Division Panel to the Cart. Align the 2 threaded holes on the Decorative Inside Plate and 2 holes on the Rear Panel with the holes
on the Division Panel. Tighten securely by using 4 of the 1/4"x1/2" Phillips Head Screws provided. See Fig. 7
SHELF
Figure 5
CART SIDE
lY
12
DOOR | STOP | j |
FOR | MAGNETS | DOOR |
|
| BRACKET |
TANK PULL-OUT
TRAY BRACKET
CART SIDE
!
CART SIDE
Figure 6 | Figure 7 |
BRACKET
|
| J_ |
|
|
DECORATIVE | _\ |
|
| DECORATIVE |
|
| PANEL | ||
PANEL | DECORATIVE |
|
| |
| INSIDE PLATE | BOTTOM | 11 | DECORATIVE |
|
| INSIDE PLATE | ||
|
| SHELF | ||
|
|
|
|
DIVISION PANEL gas model only)
REAR
PANEL