Installing Manual Lighting Stick
1.Attach the Manual Lighting Stick to the Left Bowl Support Bracket as shown in Fig. 11. Align the hole at the end of Manual Lighting Stick Wire with the threaded hole on the Left
Bowl Support Bracket. Tighten securely using the M4x8mm Phillips Head Screw.
Installing Side Shelf and Cart Side Handle
1.Remove the white protective film from the stainless steel Side Shelf,
2.Enlisting the aid of an assistant, attach Side Shelf to left side of grill. Align the holes on Side Shelf with the threaded holes on left Outside Bowl
Panel. Tighten securely using 4 of the 1/4"x3/4" Phillips Head Screws provided. See Fig. 12.
3.Enlisting the aid of an assistant, attach Cart Side
Handle to right side of grill. Align the holes on Cart Side Handle with the threaded holes on
right Outside Bowl Panel. Tighten securely using 4 of the 1/4"x3/4" Flat Head Screws provided. See
Fig. 12.
Ignitor Battery Installation - See Fig. 13
1, Unscrew the Ignitor Cap located on the grill Control Panel and remove the Contact and
Spring from each Ignitor Slot,
2.Place each supplied AA battery into each Ignitor Slot. Be sure to place the positive pole facing toward you. See Fig. 13
3.Place the Spring over the AA battery, then place the Contact on top of the Spring. Screw
the Ignitor Cap back onto the grill Control Panel.
4.Remove any protective film from outside and inside of Grill Head.
IMPORTANT: Before use of this grill please refer to Cleaning Exterior Stainless Steel
Surfaces found on page 21 of this Owner's Manual.
Figure 11
OUTSIDE BOWL
PANEL-LEFT
M4x8mm PHILLIPS
HEAD SCREW
I _MANUAL LIGHTING
STICK
Figure 12
SIDE
GRILL HEAD
OUTSIDE BOWL
PANEL-RIGHT
CART SIDE
HANDLE
Figure 13
IGNITOR SLOT
.j"
IGNITOR CAP
BATTERY
CONTACT
14