Aussie 6122S8X641, 6112S8X641 Step Heat Shield Assembly, Step Manifold and Piezo Igniter Assembly

11

!CAUTION

To reduce the risk of a laceration hazard, wear protective gloves when handling parts that have sharp edges.

Step 7

Heat Shield Assembly

Attach the Heat Shield and the Front Side Table Support to the top of the Front U-Leg with 2) 1/4-20 x 1.5” Bolts. Insert the bolts through the Heat Shield then the U-Leg then into the threaded inserts in the Front Side Table Support.

1/4-20 x 1.50” Bolt

2 pcs

Front

Side Table

Support

Heat Shield (under leg)

Step 8

Manifold and Piezo Igniter Assembly

NOTE: Regulator hose is shipped attached to the Manifold.

A. Insert valve stems out through front of the Control Panel so that the holes in the valve brackets align with the holes in the Control Panel. Fasten in place with 4) M4 x .31” Bolts through the Control Panel into the valve brackets. The Regulator hose will be on the LEFT side.

B. Install the Piezo Igniter by first, removing the large nut shipped threaded in place on the igniter, then inserting the igniter through the large hole on the left side of the Control Panel and fastening in place with the large nut previously removed.

M4 x .31” Bolt

4 pcs

Model 6122 with side burner valve

Piezo Igniter Large Nut

B

A

Model 6112 without side burner valve