Aussie 6122S8X641, 6112S8X641 manual How to Perform a Leak Test First Time USE and as required

Page 25
Model 6112 ONLY
Be sure to route the regulator hose UNDER the Clyinder Retainer Wire as shown below.

25

How to Perform A Leak Test “FIRST TIME USE” and as required

Supplies Needed for a Leak Test:

Clean paint brush

Water

Dish washing liquid

1.Use an LP Gas Cylinder equipped with an OPD (Overfill Prevention Device) and have it filled at an authorized LP gas dealer by a qualified attendant.

2.Make sure all grill Control Panel Knobs are turned to the “Off” position and verify that the LP Gas Cylinder valve is closed by turning the knob on the LP Gas Cylinder clockwise until it stops.

3.Mix one part of water with one part of dish washing liquid.

4.With the regulator hose connected to the LP Gas Cylinder, turn the knob on the Cylinder counterclockwise. (Fig. 1)

 

Fig. 1

Check for leaks at

 

 

Coupling

 

Cylinder Valve and

 

Regulator Connection

Nut

 

 

and Fittings

 

 

 

 

Fig. 2

5.Check for leaks by brushing the soap solution on all gas valves, hose connections and fittings. (Shown by the heavy arrows in Fig. 2 & 3) Make sure you generously brush the locations with the soap solution, completely surrounding the connections and fittings.

Fig. 3

Image 25
Contents For Outdoor Household Use Only. Not for Commercial Use 6122S8X6416112S8X641Carbon Monoxide Hazard Tools Required for AssemblyPreparation for Assembly ContentsParts Illustration Model 6122S8X641 Key Description Quantity Parts List- Model 6122S8X641Description Quantity Parts Illustration Model 6112S8X641 Parts List- Model 6112S8X641 Step Front Leg Frame Assembly Assembly InstructionsStep Rear Leg Frame Assembly Step Rear Crossbrace Assembly Step Side Table Support Assembly Step Cart Frame AssemblyStep Manifold and Piezo Igniter Assembly Step Heat Shield AssemblyStep Shroud Assembly Step Control Panel to Cart Frame AssemblyStep Wheel Assembly Step Shroud to Cart AssemblyModel 6122 only Side Burner Valve Assembly Step Side Tables to Cart AssemblyStep Drip Cup Wire Assembly Step Bowl to Cart AssemblyStep Main Burner Assembly Model 6122 only Side Burner Assembly Model 6122 only Side Burner Electrode AssemblyElectrode Wire Plug Assembly Step Main Burner Electrode AssemblyStep Hood/Hinge Assembly Step Hood Handle AssemblyStep Cooking Grid / Control Knob Assembly Step Flavor Activator / Warming Rack AssemblyDrip Cup Assembly Step Cylinder Blocking Wire AssemblyCylinder Retainer Wire Assembly StepUsing Gas Connecting/Disconnecting the GasLP Gas Cylinder LP Hose and Regulator Connecting LP Gas CylinderInstallation Codes Before Using Your LP Gas GrillSelecting a Location Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Check The Flame Lighting the Grill Using the Pulse-Spark IgnitorManual Lighting of the Grill on Lighting the Grill Using the Piezo IgnitorManually Lighting the Grill Manually Lighting the Side Burner Lighting the Side Burner Model 6122 OnlyManually Lighting the Side Burner Grill Cooking Direct Method Cooking On the Gas GrillDirect Cooking on the Grids Roasting Indirect MethodIndirect Cooking Roasting End of Cooking Session Warming RackCleaning the Grill Care and MaintenanceHow to Clean the Burners Screw Storage Emergencies TroubleshootingMaintenance Clean the Burners. See How to Clean Burners in CareSee How to Clean Burners in Care and Maintenance Important Notice ProblemMeco Corporation Limited Warranty Limited Warranty