Aussie 6805, 6804 manual Manually Lighting the Side Burner

Page 26

26

Manually Lighting the Side Burner

!WARNING

To reduce the risk of serious bodily injury or death from fire, explosion or burn hazard:

Open Side Burner Lid before lighting the grill to prevent an explosion from gas build-up.

When manually lighting Side Burner, use Matchlight Holder.

1.Open the Side Burner Lid.

2.IMPORTANT: Make sure Side Burner Control Knob is turned “Off” first.

3.Turn the LP Gas Cylinder valve open counterclockwise until it stops. (Fig. 8)

4.Push Side Burner Control Knob in and turn counterclockwise to the High position.

5.Hold lit Match near Burner.

6.If the Burner fails to light, repeat Steps 3-4.

If the burner fails to light after three or four attempts following Steps 3-6, turn the Side Burner Control Knob to the “Off” position and close the LP Gas Cylinder valve to dissipate an accumulated gas. Wait five minutes; then repeat the lighting procedure.

NOTE: If the Burners still fail to light, refer to Troubleshooting Section.

Hold lit match near Burner

Fig. 14

Side Burner Control Knob

 

Lighting the Side Burner Sear Burner or Rotisserie Burner Model 6805

NOTE: Do not operate the Sear burner and Rotisserie burner at the same time. Do not use the Rotisserie burner when main burners are in use. Remove the Warming Rack when using the Rotisserie Burner to prevent damage to the Warm- ing Rack.

1.Open lid during lighting.

2.Make sure the Side Burner Knob, Sear knob or Rotisserie knob is in the “Off” position.

3.Turn on LP Gas Cylinder.

4.Push in and turn the Side, Sear or Rotisserie knob to the High position and hold in for 3-4 seconds. While holding the knob in, push the starter button until the Burner is lit. Release the Starter Button but continue to hold the knob in for another 10 seconds to allow the complete heating of the safety sensor.

5.If ignition does not occur in 5 seconds, turn the burner knob to the “Off” position and wait 5 minutes before repeating the lighting procedure.

Image 26
Contents 68046805 For Outdoor Household Use Only. Not for Commercial UseTools Required for Assembly Supplied with Grill Carbon Monoxide HazardContents Preparation for AssemblyPacking List- Model Box DescriptionPacking List- Model Step Cabinet Bottom Assembly Assembly InstructionsStep Caster Assembly Step Side Panel Assembly Step Front Crossbar Assembly Step Cabinet Upright AssemblyCenter Wheel Assembly Model Door Handle Assembly Step Cylinder Guard AssemblyCylinder Blocking Wire Assembly StepStep Drawer Assembly Drawer PositioningStep Door Assembly Step Hood/Body To Cart AssemblyStep Side Table Assembly Side Burner Valve Assembly Side Burner Valve ConnectionSide Burner Grid Assembly Step Side Burner Igniter Wire ConnectionStep Side Burner Control Knob Assembly Step Warming Rack Assembly Step Bottom Body Panel AssemblyFoil Pan/Grease Pan Assembly Step Flame Diffuser/Cooking Grid Assembly Step Battery in Igniter InstallationLP Gas Cylinder Connecting/Disconnecting the GasUsing Gas Connecting LP Gas Cylinder LP Hose and RegulatorSelecting a Location Before Using Your LP Gas GrillInstallation Codes Performing a Leak TestHow to Perform a Leak Test First Time USE and as required Model Lighting the Grill Using the Pulse-Spark Ignitor Off positionLighting the Side Burner Sear Burner or Rotisserie Burner Manual Lighting of the Grill onManually Lighting the Grill Manually Lighting the Side Burner Lighting the Side BurnerCheck The Flame Manually Lighting the Side Burner Cooking On the Gas Grill Grill Cooking Direct MethodIndirect Cooking Roasting Roasting Indirect MethodDirect Cooking on the Grids Warming Rack End of Cooking SessionCare and Maintenance Cleaning the GrillHow to Clean the Burners Open up Storage Troubleshooting EmergenciesSee How to Clean Burners in Care and Maintenance Then stops when full Rises up while fillingParts Illustration- Model Parts List- Model Key Description QuantityParts Illustrations- Model Limited Warranty Meco Corporation Limited Warranty