Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure that the floor covering is firmly fixed, or removed to prevent it being disturbed when moving the cooker around. You will need the levelling tool.
Remove the polystyrene base pack. From the front tilt the cooker forward and remove the front half of the polystyrene base.
Repeat from the back and remove the rear half of the poly base.
LOWER THE TWO REAR ROLLERS.
First fit the levelling tool on the hexagonal adjusting nut as shown below.
Unfold the rear edge of pack base tray. Open the grill door and the Tall oven door. Grip under the facia panel and lift the front of the cooker.
Carefully push the cooker backwards off the pack base. Remove the pack base tray. Position the cooker close to its final position leaving just enough space to get behind it.
Do not use the door handles or control knobs to manoeuvre the cooker. Use the hotplate and griddle bowl areas.
Make 10 complete (360º) turns clockwise. (This means turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are two adjusting nuts, one for each roller, at both the front bottom corners of the cooker.
Levelling
You are recommended to use a spirit level on a shelf in one of the ovens to check for level.
Place the cooker in its intended position taking care not to twist it within the gap between the kitchen units as damage may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the cooker. To adjust the height of the rear of the cooker use the levelling tool supplied to turn the adjusting nuts at the front bottom corners of the cooker. To set the front feet turn the bases to raise or lower.
Fitting a stability bracket
A stability bracket or chain (not supplied by with the cooker) should be fitted when the cooker is connected to a flexible gas supply.
When fitting a stability bracket read these instructions together with the leaflet supplied with the bracket.
26