Rangemaster U109360 - 01 manual Servicing Notes

Page 29
To Remove a Side

WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

Servicing Notes

Disconnect from electricity supply before commencing servicing, particularly before removing any of the following: control panel, side panels, ceramic hob, or any of the electrical components or cover boxes. Before electrical reconnection check that the appliance is electrically safe.

1.To Remove a Side Panel

Disconnect from electricity supply.

Pull the cooker forward.

Pull off the push fit control panel end caps at each end and remove the end fixing screws under the end cap.

Remove the retaining screws for each panel (1 at the front and 2 at the rear). The lower front retaining screws (one each side) are situated beneath the lower edge at the front corners of the side panels

Reassemble in reverse order.

2. To Lift up the Ceramic Hob

Pull the cooker forward.

Unscrew the 2 screws which are located at the rear of either side of the cooker underneath the grill trim

Push the hob backwards to release the front catchment bracket.

Lift the hob.

Hold the hob in place using the rod attached to the underside of the hobplate, by locating the loose end into the central hole in the top of the inner control panel.

Caution

The ceramic hob material is much more sensitive to scratches on the underside than the top.

Lift up the ceramic hob at the front and prop in position with a non-metallic prop.

Take care not to touch or scratch the underside of the ceramic as this will weaken the material and cause the top to shatter.1.

Panel

3. To replace a hob element.

Lift up the ceramic hob see 2. The elements are now accessible.

4To Remove the Control Panel

Disconnect from electricity supply.

Remove the handrail by removing the 2 end bracket fixing screws.

Pull off all the control knobs. Open the grill and oven doors and remove the control panel fixing screws underneath the control panel. The screws directly below the clock are for the clock fixing bracket - don’t remove them at this stage.

Lift the control panel, pull forward and disconnect the wiring from the rear.

Reassemble in reverse order. When replacing leads refer to the wiring diagram. Check operation of timer.

5. To Remove Oven Light Switch

Remove control panel (see 4).

NB The old switch may be destroyed during removal.

Remove switch button and old switch from its bezel by gripping the switch body behind the control panel and twisting sharply.

The switch bezel can then be removed by folding back its locking wings and pushing forward. Fit the new bezel to the control panel by first lining up the raised key on its body with the cut-out in the control panel and pushing it in from the front. Assemble the new switch to the bezel by lining up the key sections and pushing home. Fit the new button by pushing in from the front.

Replace control panel in reverse order and test for correct operation.

6.To Remove Electronic Timer

Disconnect from electricity supply.

Pull off the timer control buttons and remove the control panel (See 4). Remove the timer/mounting bracket assembly from the control panel by removing the two fixing screws. Remove the timer from its mounting bracket by depressing the plastic lugs on the timer case, at the same time pulling the unit forward.

Reassemble in reverse order. When replacing leads refer to the wiring diagram. Check operation of timer.

7. To Remove a Thermostat

Lift up the ceramic hob top (see 2). Remove control panel (see 4). Open appropriate oven door and remove oven furniture.

RH oven

Remove thermostat phial cover (2 screws). Unclip the thermostat phial from the clips in the oven back.

LH oven

Pull cooker forward to gain access to the cover box at the rear of the cooker. Remove the screws securing the cover and lift clear.

29

Image 29
Contents Deluxe Installation & Service Instructions U109360Be safe Make sure that the cooker is wired in and switched onElectricity on Peculiar smellsContents Use only pans that are suitable for ceramic hobs HobNever cook directly on the surface Glide-out Grill Ovens To set the time of day ClockTo time something that’s cooking minute minder To stop automaticallyClock Special Features Cooking using the timerAuto is showing, you want to reset to manual cooking Both Ovens Multi-function oven functionsRapid Response DefrostFanned grilling in the oven Fan ovenFan assisted oven Conventional oven top and base heatMain Oven shelves Handyrack Maximum weight that can be held bySupplied meat tin, which is designed to fit Handyrack. Any other vessel could be unstableTall oven shelves Oven lightPage Oven cooking guide Before use It’s very easy to clean the Hob with a recommended cleanerGlide out Grill Do not put the side runners in a dishwasher Control Panel and DoorsSide panels of the main oven can be removed Main OvenTall Oven Cleaning Table Moving your cooker TroubleshootingLeft hand Main oven not coming on when turned on manually Power failureLeft hand Main oven not coming on when automatic cooking Oven temperature getting hotter as the cooker gets olderClean only parts listed in this guide General Safety InstructionsDo not use the surface as a cutting board Take care that no water seeps into the applianceSpecification of this cooker should not be altered You will also need the following tools InstallationChecking the parts Positioning the CookerUnpacking the Cooker Fitting a stability bracket Moving the CookerLevelling Hotplate Electrical ConnectionOven check Fitting the plinthThank you Door adjustmentCustomer care Servicing Notes To Change Grill Controller To Adjust the Main Oven Door Catch KeepTo Remove Grill Door To Remove Main Oven DoorTo Remove an Oven Inner Back To Remove Grill ElementTo Remove an Oven element Thermal Cut-Out To Remove Oven ElementTechnical Data Page Key to circuit diagram Colour Code 1kW 02kW A21.65kW 56kW 121206