Trane PKGP-PRC001-EN Factory Installed Options, High Pressure Cutout, Two-Inch Pleated Filters

Page 49

Mechanical Specifications

Factory Installed Options

Black Epoxy Pre-Coated Coils

The black epoxy coils have a thermoset vinyl coating that is bonded to the aluminum fin stock prior to the fin- stamping process.The pre-coated coils are an economical option for protection in mildly corrosive environments.

Hinged Access Doors

Sheet metal hinges are available on the Filter/Evaporator Access Door and the Compressor/Control Access Door.This option is available on all downflow models.

High Efficiency Motors

This option is available with efficiency ratings from 86.5 up to 91.0. It is not available for all models.

High Pressure Cutout

This option is offered for units that do not have High Pressure cutout as standard. TheVoyager units with High Pressure Cutout as standard are WC*180-240B.

Powered or Unpowered Convenience Outlet

This option is a GFCI, 120v/15amp, 2 plug, convenience outlet, either powered or unpowered.When the convenience outlet is powered, a service receptacle disconnect will be available.The convenience outlet is powered from the line side of the disconnect or circuit breaker, and therefore will not be affected by the position of the disconnect or circuit breaker.This option can only be ordered when theThrough the Base Electrical with either the Disconnect Switch, or Circuit Breaker, option is ordered.This option is available on all downflow models.

Supply and/or Return Air Smoke Detector

With this option installed, if smoke is detected, all unit operation will be shut down. Reset will be manual at the unit. Return Air Smoke Detectors require minimum allowable airflow when used with certain models. See the Installation, Operation, and Maintenance (IOM) manual for the models affected and the minimum allowable airflow required.This option is available on all downflow models.

Through the Base Electrical with Circuit Breaker

This option is a thermal magnetic, molded case, HACR Circuit Breaker with provisions for through the base electrical connections.The circuit breaker will be installed in a water tight enclosure in the unit with access through a swinging door. Factory wiring will be provided from the switch to the unit high voltage terminal block.The circuit breaker will provide overcurrent protection, be sized per NEC and UL guidelines, and be agency recognized by UL/CSA.This option is available on all downflow models.

Through the Base ElectricalWith Disconnect Switch

Three-pole, molded case, disconnect switch with provisions for through the base electrical connections are available. The disconnect switch will be installed in the unit in a water tight enclosure with access through a swinging door. Factory wiring will be provided from the switch to the unit high voltage terminal block.The switch will be UL/CSA agency recognized. Note:The disconnect switch will be sized per NEC and UL guidelines but will not be used in place of unit overcurrent protection.This option is available on all downflow models.

Through the Base Utilities Access

An electrical service entrance shall be provided allowing electrical access for both control and main power connections inside the curb and through the base of the unit. Option will allow for field installation of liquid-tight conduit and an external field installed disconnect switch.

Two-Inch Pleated Filters

Two inch pleated media filters shall be available on all models.

PKGP-PRC001-EN

49

Page 48 Page 50
Image 49
Page 48 Page 50
Contents Packaged Heat Pumps Introduction Packaged Rooftop Air ConditionersContents Factory Installed Options Field Installed Options Features BenefitsFactory or Field Installed Options Easy to Install, Service and Maintain Features and BenefitsQuality and Reliability ColoredAnd NumberedWiring Clogged Filter/Fan Failure SwitchPower Exhaust Option Quick-Access PanelsRigorous Testing Added Efficiency Easy to Install and ServiceBarometric Relief Power Exhaust AccessoryCondensate Trap Clearance RequirementsHeating Capacity Cooling CapacityStep To Find Capacity at Intermediate ConditionsModel Number Description Digits 9, 10 Factory Installed OptionsCapacity MBh Data12½Ton GeneralTable GD-1 General Data EER2Table GD-2 General Data General DataMBH SHC MBH SHC MBH SHC PerformanceWC*180B Data15TonMBH SHC Data20Ton Three Phase WCD240BBHP Table PD-6 Evaporator Fan Performance 12½ Ton WC*150BBHP RPM Table PD-8 Evaporator Fan Performance 15 Ton WCH180B Table PD-7 Evaporator Fan Performance 15 Ton WCD180BCFM RPM BHP RPM BHP Table PD-9 Evaporator Fan Performance 20 Ton WC*240BTable PD-10 Standard Motor & Drive/Fan Speed RPM Data12½ 20TonsTable PD-12 Oversized Motor & Drive/Fan Speed RPM WCH240B WCD240BData12½Ton Data15Ton Data20Ton Table PD-20 Auxiliary Electric Heat Capacity Table PD-19- Heating Capacity Correction FactorsControls Field Installed Control OptionsElectrical Data Table ED-1 Unit WiringRPM FLA LRA 208/230 Volts Three Phase Volts Three Phase WCD150BW AYDHTRKW36A AYDHTRKW18AAYDHTRKW54A AYHHTRNW18AFLA LRA RPM RLA LRA Disconnect Switch Byothers Zonesensors Rooftop Unit Zone Sensors -Typical Number Of WiresJobsite Connections Typical Wiring 12½ 20TonsWiring 12½ 20Tons Wiring 12½ 20Tons Wiring 12½ 20Tons 12½, 15Ton Dimensional DataDownflow Unit Clearance Horizontal Unit Supply/Return and Unit Clearance Downflow Duct Connections Field FabricatedDimensional 19 5/16 73 7/16 26 5/16 Table DD-1 Dimensional 12½ 20Tons DataAccessoriesTable DD-2 Options FiopsOptions Fiops Table DD-3 12½-20 Tons Table W-1 Accessory Net Weights Lbs Weights 12½ 20TonsTable W-1 Weights 12½ 20Tons Mechanical Specifications High Pressure Cutout Factory Installed OptionsTwo-Inch Pleated Filters Economizer Downflow Factory or Field Installed OptionsFrostat Reference or Comparative EnthalpyPowered Exhaust Field Installed OptionsManual Outside Air Damper Roof Curb DownflowTrane

PKGP-PRC001-EN specifications

The Trane PKGP-PRC001-EN is a highly efficient and versatile rooftop packaged unit designed for commercial HVAC applications. This advanced system showcases Trane's commitment to quality, reliability, and energy efficiency while catering to a diverse range of climate control needs. Its innovative technologies and features make it a top choice for building owners and facility managers looking to enhance indoor comfort while minimizing energy costs.

One of the standout characteristics of the PKGP-PRC001-EN is its impressive cooling and heating capacities, which ensure optimal performance in various conditions. This unit is equipped with advanced scroll compressors that provide efficient cooling and heating, enabling it to maintain a comfortable environment even during extreme temperature fluctuations. The unit also features a multi-position design, allowing for easy installation and adaptation to different rooftop configurations.

In terms of energy efficiency, the PKGP-PRC001-EN excels with its high Seasonal Energy Efficiency Ratio (SEER) and Energy Efficiency Ratio (EER) ratings. These ratings signify its ability to deliver exceptional cooling performance while consuming less energy, ultimately lowering operational costs for facility owners. Additionally, the unit complies with the latest energy standards, including ASHRAE 90.1 and DOE regulations, further emphasizing its commitment to sustainability.

Another notable feature is its advanced control system. The PKGP-PRC001-EN comes equipped with Trane's proprietary Tracer™ controls that provide precise temperature and humidity management. These controls are user-friendly, allowing for easy programming and monitoring of the system's performance. Furthermore, the unit can be integrated with building management systems (BMS), offering greater control and efficiency.

The design of the PKGP-PRC001-EN also emphasizes durability and ease of maintenance. Constructed with high-quality materials, this unit withstands harsh environmental conditions while minimizing wear and tear over time. Access panels and a structured layout allow for straightforward maintenance, ensuring that service and repairs can be conducted quickly and efficiently.

In summary, the Trane PKGP-PRC001-EN is more than just an HVAC unit; it is a comprehensive solution for efficient heating and cooling in commercial settings. With its cutting-edge technologies, energy-efficient performance, and user-friendly control capabilities, this rooftop packaged unit is an excellent choice for those looking to optimize their HVAC operations while embracing sustainability and reliability.
Top Page Image Contents