HOW TO USE THE POWER SOURCE
Battery life
•You can use the unit for approximately three hundred measurements with one charge.
•Approximate life of battery is two years. However the battery life from each charging may be shortened depending on the state of using. If the interval between charging becomes short and
the 
icon appears frequently, replace it.
HOW TO MEASURE BLOOD PRESSURE
Charging time
•At approximately five seconds after connecting the AC adapter, the unit will start battery charging automatically.
•While the battery is being charged, the 
icon turns on.
•The battery can be completely charged in approximately twelve hours.
Battery low
• When the |
|
|
|
| icon starts to blink, twenty to thirty measurements remain on the battery. |
|
| ||||
|
|
|
|
| However if the Battery Low Mark starts to blink, charge it soon. |
|
|
|
•If the 
icon is displayed, the battery is low and the unit cannot operate. Please charge the battery.
If cuff inflation does not stop, remove the cuff or pull out the air tube from the main unit.
General advice
• Patients should not touch the unit.
Confirm readings with the stethoscope when an irregular pulse wave is displayed or when the measured value is questionable or erratic.
Do not use a cellular phone near this unit.
Do not use this unit in a vehicle.
Automatic Power Off
List of Measurement Modes
•When using the unit with the battery, the unit will turn off automatically after five minutes of inactivity.
•While the AC adapter is connected, the Auto Power Off function does not work.
To measure
only once
To measure two
times (or three times) automatically and consecutively
To measure by using a stetho- scope
SINGLE Mode
AVG Mode
MANU Mode
Refer to Page
20.
Refer to Page
22.
Refer to Page
24.
18 | 19 |