HOW to Measure

BLOOD PRESSURE (IN SINGLE MODE)

1. Push the ON/OFF (power) Button to turn on the power.

2. Set the MODE Selector to "SINGLE".

3. Set the P-SET (inflation level) Knob to "AUTO" or to the target pressure value.

4.Measure the patient’s arm size, and wrap appropriate cuff over the patient's arm. (Refer to Pages 14 and 15.)

HOW TO MEASURE

BLOOD PRESSURE (IN SINGLE MODE)

5. Push the START Button to start the measurement.

• Do not push the START Button without wrapping the cuff.

• If you want to stop measurement, push the STOP Button. The cuff will rapidly deflate.

6. The measurement results are displayed.

• While the battery pack is in use, the monitor will turn off automatically after five minutes of inactivity and the display (measurement results) will disappear. (Automatic Power Off)

7. Push the ON/OFF (power) Button to turn off the power.

If the monitor determines that the pressure value is not correct, an error display appears (Er1 to 9). In this case, refer to Page 28 and start the measurement again.