Omron Healthcare BP652 instruction manual Error Indicators, Symbol Cause Correction

Page 25

ERROR INDICATORS

SYMBOL	CAUSE	CORRECTION

	Monitor could not	Take another measurement and
	Monitor could not	remain still until the measurement is
	detect pulse wave.	remain still until the measurement is
	detect pulse wave.	complete.
		complete.
	Cuff under-inflated.	Remove the monitor from your
	Cuff not applied	Remove the monitor from your
	correctly.	wrist.
		Read “Taking a Measurement”.
		Read “Taking a Measurement”.
	Cuff over-inflated.	Wait 2-3 minutes.
		Take another measurement.

	Device error.	Contact Customer Service.

	Movement during	Keep still and take another
	measurement.	measurement.
		Remove the monitor from your
		wrist. Wait 2-3 minutes and then
	Irregular or weak	take another measurement. Repeat
	Irregular or weak	the steps in section “Applying
	pulses are detected.	the steps in section “Applying
	pulses are detected.	the Wrist Cuff.” If this symbol
		the Wrist Cuff.” If this symbol
		continues to appear, contact your
		doctor.
	Batteries are worn.	Replace the batteries.
	Batteries are worn.	Refer to “Battery Installation”.
		Refer to “Battery Installation”.

25

Image 25

Contents Series Automatic Wrist Blood Pressure Monitor Table of Contents Introduction Operating the Device Safety InformationCare and Maintenance Before Taking a Measurement Components Know Your UnitUnit Display Positioning indicator Diastolic blood pressureIrregular Heartbeat Symbol Display SymbolsMovement Error Symbol Monitor is not intended to be a diagnostic device Use only 1.5V AAA alkaline batteries with this device Battery InstallationBattery Replacement To Start the Setting Setting the Date and TimeSetting the Year Setting the MonthSetting the Hour Setting the DAYSetting the Minute Setting the Positioning Indicator Setting the Advanced Positioning Sensor APSSetting the Buzzer Setting for Right or Left Wrist MeasurementResetting to the Default Setting Applying the Cuff on the Left Wrist Applying the Wrist CuffApplying the Cuff on the Right Wrist Taking a Measurement Press the START/STOP button to turn the monitor off Averaging Function Using the Memory FunctionTo Display the Measurement Values To Delete ALL Values Stored in the Memory Clean the monitor with a soft dry cloth Care and MaintenanceSymbol Cause Correction Error IndicatorsProblem Causes and Solutions Troubleshooting TipsFCC Statement Limited Warranty Specifications Omron Healthcare, Inc