DATE & TIME SET PROCEDURE
1.To adjust the date/time, press the Set button 
. The display will show a blinking number showing the month.
2.Change the month by pressing the 
button. Each press will increase the num- ber by one in a cycling manner. Press the
Set button
again to confirm the entry, and the screen will show a blinking num- ber representing the day of the month.
3.Change the date and time as described
in Step 2 above, using the 
button to change the numbers and the Set button 
to confirm the entries.
4.A “0” will reappear as the blood pressure monitor is ready for measurement again.
Press the 
button
blinking month
increasing month
confirm the entry
repeat process to set date and time
15
APPLYING THE CUFF
1.Remove all watches, wrist jewelry, etc. prior
to attaching the wrist |
| |
monitor. Clothing |
| |
sleeves should be rolled |
| |
Fig. A | ||
up and the cuff should | ||
| ||
be wrapped around |
| |
bare skin for correct |
| |
measurements. |
| |
2. Apply cuff to left wrist |
| |
with palm facing up as | Fig. B | |
shown in Fig. A. | ||
| ||
3. Make sure the edge |
| |
of the cuff is about |
| |
1/4”~1/2” (1 cm) from |
| |
the palm as shown |
| |
in Fig. B. |
|
16