HoMedics BPW-201 manual Troubleshooting, Symptoms Possible Correction Causes

installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

37

TROUBLESHOOTING

If any abnormality arises during use, please check the following points:

SYMPTOMS	POSSIBLE	CORRECTION
	CAUSES
Unit does not turn	Batteries have	Replace them
on when the START/	run down.	with two new AAA
STOP button is		alkaline batteries.
pushed.
	Battery polarities have	Re-insert the
	been positioned incor-	batteries in the
	rectly.	correct positions.
EE measurement	Cuff has been placed	Wrap the cuff properly
error symbol shown	incorrectly.	so that it is positioned
on display or the		correctly.
blood pressure value	Did you talk or move	Measure again. Keep
is displayed exces-	during measurement?	wrist steady during
sively low		measurement.
(or high).	Shaking of the wrist
	with the cuff on.
E1 error symbol	Air circuit	Measure again.
shown on display	abnormality.
E2 error symbol	Inflation pressure exceed-	Switch the unit off,
shown on display	ing 300 mmHg.	then measure again.
E3 error symbol	Error determining	Measure again.
shown on display	measurement data.
EP error symbol	System error.	Measure again.
shown on display

Note: If the unit still does not work, contact HoMedics Consumer Relations. Under no circumstance should you disassemble or attempt to repair the unit by yourself. Contact information for HoMedics Consumer Relations Department can be found on the warranty page (See page 41).

38