Graco 3A1696C important safety instructions Equipment Misuse Hazard

Page 4

Warnings

WARNING

EQUIPMENT MISUSE HAZARD

Misuse can cause death or serious injury.

Do not operate the unit when fatigued or under the influence of drugs or alcohol.

Do not exceed the maximum working pressure or temperature rating of the lowest rated system component. See Technical Data in all equipment manuals.

Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings. For complete information about your material, request MSDS from distributor or retailer.

Do not leave the work area while equipment is energized or under pressure. Turn off all equipment and follow the Pressure Relief Procedure when equipment is not in use.

Check equipment daily. Repair or replace worn or damaged parts immediately with genuine manufacturer’s replacement parts only.

Do not alter or modify equipment.

Use equipment only for its intended purpose. Call your distributor for information.

Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.

Do not kink or over bend hoses or use hoses to pull equipment.

Keep children and animals away from work area.

Comply with all applicable safety regulations.

CARBON MONOXIDE HAZARD

Exhaust contains poisonous carbon monoxide, which is colorless and odorless. Breathing carbon monoxide can cause death.

Do not operate in an enclosed area.

TOXIC FLUID OR FUMES HAZARD

Toxic fluids or fumes can cause serious injury or death if splashed in the eyes or on skin, inhaled, or swallowed.

Read MSDSs to know the specific hazards of the fluids you are using.

Store hazardous fluid in approved containers, and dispose of it according to applicable guidelines.

BURN HAZARD

Equipment surfaces and fluid that’s heated can become very hot during operation. To avoid severe burns:

Do not touch hot fluid or equipment.

PERSONAL PROTECTIVE EQUIPMENT

You must wear appropriate protective equipment when operating, servicing, or when in the operating area of the equipment to help protect you from serious injury, including eye injury, hearing loss, inhalation of toxic fumes, and burns. This equipment includes but is not limited to:

Protective eyewear, and hearing protection.

Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.

CALIFORNIA PROPOSITION 65

The engine exhaust from this product contains a chemical known to the State of California to cause cancer, birth defects or other reproductive harm.

4

3A1696C

Image 4
Contents Important Safety Instructions Line Striping SystemTable of Contents Fire and Explosion Hazard Equipment Misuse Hazard Component Identification Component Function Pressure Relief Procedures RPS 2900 Pump Fluid Pressure ReliefBead System Pressure Relief Air System Pressure ReliefDrain Oil Changing Hydraulic OilRefilling Oil Compressor Belt and Hydraulic Pump Belt Belt RemovalBelt Installation Install side guard 105 by tightening eight screws Hydraulic Pump Replacement RemovalInstallation Compressor Replacement Perform Pressure Relief Procedures,Install air line 145 to compressor Engine Replacement Engine RemovalEngine Installation Pulley InstallationInstallation Junction Box Circuit Board ReplacementRemoval Troubleshooting Paint Guns and Bead GunsFine Gun arm wobbles Programmable Skipline Controller Air and Bead System See Air Compressor Belt ReplacePaint Pumps Kohler EnginePaint and Paint Manufacturers Schematics 24F472, Controller Wiring DiagramsControl Cable Diagram for RoadPak System Schematics -16G161, Cable, Gun Arm 16G161, Cable, Gun Arm16G049, Valve, Air Solenoid Schematics 16G049, Valve Air Solenoid15E943, Senor Distance 16G049, Valve, Air Solenoid Graco Standard Warranty Graco Information