V I . C O M F O R T A D J U S T M E N T S
After becoming familiar with your Jazzy’s operation, you may find the need to make some adjustments to increase your comfort, such as seat height and angle, armrest height and angle, footrest height and angle, and the joystick’s position.
CAUTION: If your Jazzy 1400 was configured at your Pride provider or service center, please consult your health care professional before changing the seat position or making any other adjustment. Some adjustments may degrade your Jazzy’s performance and safety by changing its center of gravity.
SEAT HEIGHT AND ANGLE
If your Jazzy 1400 is equipped with the standard Versa Seat, refer to the “Versa Seat Adjustment and Installation Guide.” If your Jazzy is equipped with optional seating, refer to the following information.
To change the seat height:
1.Remove the seat. See VII. “Disassembly” in this manual.
2.Remove the ball detent pin from each seat tower. See figure 15.
3.Raise or lower each seat tower to the desired position.
4.Install the ball detent pin into each seat tower.
5.Install the seat.
To change the seat angle:
Raise or lower only the front or only the rear seat towers.
NOTE: We suggest setting the rear towers one notch lower than the front towers to enhance the performance of your Jazzy 1400.
ARMREST WIDTH (OPTIONAL) (MEDIUM AND HIGH-BACK ONLY)
To change the armrest width:
1.Locate the two knobs on the armrest receiver bracket. See figure 16.
2.Loosen the knobs and slide the armrests in or out to the desired width.
3.Tighten the knobs.
SEAT TOWER PIN
Figure 15. Seat Tower Pin (Optional)
LOOSEN KNOB TO
MOVE ARMREST
Figure 16. Armrest Width (Optional)
18 | www.pridemobility.com | Jazzy 1400/Rev C/Sept02 |