Pride Mobility 1400 owner manual Daily Checks, Weekly Checks, To check the brakes

Page 40

X . C A R E A N D M A I N T E N A N C E

WARNING: Never use a rubber conditioner on the tread area of the tyres; doing so may make the tyres slippery and cause your Jazzy to skid.

￿ Check the tyres for wear.

￿ The body shroud has been sprayed with a clear sealant coating. You can apply a light coat of car wax to help it retain its high-gloss appearance.

￿ Check all electrical connections. Make sure they are tight

 

and are not corroded. Batteries must sit flat within the battery

 

well, with the battery terminals facing inward, toward each

 

other. Refer to the frame decal for the correct wiring layout.

 

￿ All wheel bearings are pre-lubricated and sealed. They require

Figure 39. Check Air Pressure

no subsequent lubrication.

 

DAILY CHECKS

￿With the controller turned off, check the joystick. Make sure it is not bent or damaged and that it returns to the center when you release it. Check the rubber boot around the base of the joystick for damage. Visually inspect the boot. Do not handle or try to repair it. See your authorised service center if there is a problem.

￿Visually inspect the controller harnesses. Make sure that they are not frayed or cut or have any wires exposed. See your authorised Pride provider if there is a problem with any of these harnesses.

WEEKLY CHECKS

￿Disconnect and inspect the controller and the charger harnesses from the utility tray. Look for corrosion. Contact your Pride provider if necessary.

￿Ensure that all parts of the controller system are securely fastened to your Jazzy. Do not overtighten any screws.

￿Check for proper tyre inflation. There should be 30–35 psi in each tyre. If a tyre will not hold air, see an authorised Pride provider for replacement of the tube.

￿Calibrate the joystick if a noticeable difference in performance is detected or if the joystick does not operate properly. You can do this for both the Remote Plus and Pilot controllers.

￿Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around your Jazzy.

To check the brakes:

1.Turn on the controller and lower your speed.

2.After one second, check the battery gauge. Make sure that it remains on.

3.Slowly push the joystick forward until you hear the electric brakes click. Immediately release the joystick. You must be able to hear each electrical brake operating within a few seconds of joystick movement.

Perform the brake check three more times, pushing the joystick rearwards on the second check, then to the left on the third check, and finally, to the right on the last check.

40

www.pridemobility.com

Jazzy 1400/Rev C/Sept02

Image 40
Contents Read everything This manual Before operating Your Jazzy F E T Y G U I D E L I N E S N T E N T S IIIN T R O D U C T I O N Information ExchangeMy Authorised Pride Provider is Pride Owners ClubQuick Reference Information Weight Limitations S a F E T YTransfers Motor Vehicle TransportStairs and Escalators Steps and CurbsInclines and Uneven Terrain Maximum Recommended InclineWhere do radio waves come from? Frequently Asked Questions Faqs about EMI/RFII . E M I / R F Are all powered wheelchairs susceptible to EMI/RFI? What is the FDA doing about the problem?T H E J a Z Z Y 1 4 0 JazzyRear View Specifications Utility Tray Ammeter The ammeter displays the charger’s currentOutput in amps. For more information, see IX. Batteries Charging in this manualTo put the Jazzy 1400 in freewheel mode To engage the drive motorsACTIVE-TRAC System Rear SuspensionVersa Seat Assembly Optional Seating Assembly SEAT-BACK AssemblySeat Installation Seat with H-FRAME S S E M B L YTo install the joystick Joystick InstallationTo install the power seat Seat Height and Angle C O M F O R T a D J U S T M E N T SArmrest Width Optional Medium and HIGH-BACK only Armrest Angle MEDIUM/HIGHBACK/RECLINER Armrest Height OptionalJoystick Extension SWING-AWAY JoystickFootrest Angle Optional Footrest Height OptionalElevating LEG Rests Option To adjust the headrest height To adjust the seatback anglePower Elevating Seat Option HIGH-BACK with Headrest OptionPower Seat Cautions ANTI-TIP WheelsTo adjust the anti-tip wheels Anti-Tip BracketSeat Removal I . D I S a S S E M B L YBody Shroud Removal Battery Removal To remove the batteriesI I . O P E R a T I O N Joystick and ControllerTo operate your Jazzy Controller FunctionsBattery Condition Meter Remote Plus ControllerJoystick Functions On/Off KeySpeed and Mode Adjustments Sleep ModeThermal Rollback Trouble CodesFlashing Bars Diagnosis Solution Europa Remote Controller Magnetic Locking AreaSystem Status Indicator Drive Mode Select KEYDrive Mode Indicator ON/OFF KEYOUT of Neutral AT Power UP Battery Saver FeatureTo use the joystick to control the actuators Code Title Corrective Action To charge the batteries using the onboard charger B a T T E R I E S a N D C H a R G I N GBatteries Charging the BatteriesOFF-BOARD Charger Battery BREAK-INTo break in new batteries for maximum efficiency Daily Use Infrequent UseWhy do my new batteries seem weak? What type of battery should I use?How can I ensure maximum battery life? What about public transportation? How should I store my Jazzy 1400 and its batteries?What about shipping my Jazzy? Routine Maintenance TemperatureA R E a N D M a I N T E N a N C E Should your Jazzy 1400 come in contact with waterWeekly Checks Daily ChecksTo check the brakes Cleaning Instructions Monthly ChecksYearly Checks StorageTo replace the batteries Battery ReplacementMotor Brushes When to see Your Pride Provider for Service Corrective MaintenanceTo inspect or replace the motor brushes O P T I O N a L a C C E S S O R I E S Oxygen Tank Holder Light switch is located on the body shroud. See figure I . W a R R a N T Y Warranty Exclusions Damage caused byT E S T E S
Related manuals
Manual 39 pages 55.11 Kb