V I I . D I S A S S E M B L Y
SEAT REMOVAL
You may wish to remove the seat for transportation. If you have a Versa Seat, please refer to the “Versa Seat Installation and Adjustment Guide.”
To remove the seat:
1.Turn the power off.
2.Make sure your Jazzy is not in freewheel mode.
3.Unplug the main wire harness behind the seat.
4.Simultaneously depress the two plungers on the front of the seat frame while lifting the front of the seat. See figure 30.
5. | Lift the seat up and gently lower it back onto the front | Figure 30. Removing the Seat |
| seat towers. |
|
6. | Pull the seat forward and lift it off of the rear seat towers. |
|
To remove a power seat:
1.Push down on the seat release lever.
2.Lift the seat off of the actuator.
BODY SHROUD REMOVAL
The body shroud is a
To remove the body shroud:
1.Turn the power off.
2.Make sure your Jazzy is not in freewheel mode. See IV. “The Jazzy 1400” in this manual.
3.Unplug the controller wiring harness.
4.Remove the seat.
5.Disconnect the lighting harness (if your Jazzy is equipped with lights).
6.Lift the body shroud straight up. The body shroud is attached to the metal frame by reusable fasteners. The body shroud should lift up easily.
24 | www.pridemobility.com | Jazzy 1400/Rev C/Sept02 |