Dedocking
Refitting motor drive units
1.To refit the motor drive units ensure the 6 pin plug power connectors are free.
2.Tilt and lift the locating tongue under the dedocking socket. Lower the chair until the dedocking trigger clicks into
position (Fig. 9).
4.Reconnect the motor drive unit 6 pin power plugs.
5.Fit the battery basket and the batteries, ensuring that the batteries are correctly secured with the retaining straps.
6.Connect the batteries with the connection plug, slide the battery basket into its forward postion, ensuring that it locks positively over its location studs and finally connect the 6 pin power plug to the rear battery socket (Fig 10).
7.Ensure the freewheel levers are in the drive position.
Fig. 9
6 pin connector
Battery connection plug
Ensure the levers are in the drive position
Fig.10
11 | F45 Issue 6 |
|
|