Shoprider Jetstream-L 888WAL, Streamer 888WAB Adjustment Procedures, Length, Angle, Height, Width

GMP

ISO9001

ISO14001

ISO13485

CERTIFIED

ADJUSTMENT PROCEDURES

FOOTREST ADJUSTMENTS (Fig. 11) JETSTREAM-L/M(888-WAL/WAM)

LENGTH

Pull out the safety pin (1) from the first hole in the footrest slide tube (2), adjust the footrest slide tube and refit the safety pin in the hole at the desired length.

ANGLE

Release the lock nut and adjust the bolt under the footrest (3) to adjust the footrest angle. When the re-tighten the lock nut and bolt.

(1)

(2)

(3)

Fig. 11

angle desired is reached,

ARM ADJUSTMENTS (Fig.12) JETSTREAM-L/M (888-WAL/WAM)

ANGLE

Pull up on the end of the armrests and they will flip back up allowing easy transfer in and out of the seat. Under the armrest there is a bolt and lock nut (1) that can be adjusted up or down to change the angle of the armrest.

LENGTH

Fig. 12

(3)

(1)

(2)

Located under the armrest controller bracket is a hand knob (2). By turning counter-clockwise to release, the controller bracket can be extended and reset in position by re-tightening the hand knob.

HEIGHT

Below the armrest on the down supporting tube there is a lever (3) that can be pushed down for armrest height adjustments.

WIDTH

Beneath the rear of the seat there are two hand knobs, one on each side. Release the hand knob and slide each arm assembly outward. Re-tighten the hand knob when in the desired position.

~15~