GMP
ISO9001
ISO14001
ISO13485
CERTIFIED
BATTERIES & BATTERY CHARGING
BATTERY CHARGING FOR
To recharge the Powerchair, connect the charger to the Charging Port at the front of the VSI referred to as (8) in Fig. 14. Switch on the charger.
Do not leave the charger plugged into the Charging Port if the charger is not charging. This charger is for indoor use only. Do not expose it to rain or water spray. Do not cover the battery charging vent.
One example of indicator light on the charger gives advice as follows: Red – Power on, Amber – Battery charging, Green – Charging complete. Please refer to the LED indicator description based on charging status of the charger.
Batteries that are allowed to go below a minimum voltage due to neglect will be unable to be
BATTERY CHARGING FOR
The batteries supplied with the Powerchair are specially designed and require an automatic battery charger. The battery charger is fitted with an electronic switch that terminates the charge when the batteries are fully charged.
WARNING! Only use the original manufacturer approved charger.
1.Pull the AC cord out from the Powerchair and plug male connector into
NOTE! The voltage suitable for the charger is different from districts. Please assure to use the correct AC power cord for charging.
2.While charging the indicator light will be yellow (Fig. 8).
3.When charging is complete, the indicator light will be green (Fig. 8). At this point, the charger automatically stops charging.
4.Once charged, unplug the power cord from the wall outlet and retract the cord back into place.
5.If the charger is plugged in and the Indicator light is off, the charger is disconnected. Check that all connections are secure. If Indicator light is still off, unplug AC power cord and contact your provider as soon as possible.