V . C O M F O R T A D J U S T M E N T S
To clamp the quick release fastener:
1.Make sure the lever is in the open position.
2.Turn the nut clockwise until it is snug.
3.Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed position, then turn the nut counterclockwise
Foot Platform Angle
You can adjust the angle of the foot platform with a hex key. See figure 15.
To adjust the foot platform angle:
1.Flip up the foot platform and locate the setscrew.
2.Turn the setscrew counterclockwise to raise the front of the foot platform.
3.Turn the setscrew clockwise to lower the front of the foot platform.
Controller Position
You can position the controller for either
WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.
To change the controller position:
1.Turn off the power to the controller.
2.Turn the rear shroud fasteners counterclockwise one- quarter turn. See figure 6.
3.Remove the rear shroud.
4.Unplug the controller connector(s) from the power base.
5.Cutthewiretie(s)securingthecontrollercabletothearmrest.
6.On a contour seat, flip up the armrest and loosen the setscrew. See figure 17. On the standard seat, loosen the setscrews in the mounting block. See figure 18.
7.Slide the controller out of the armrest.
8.Onacontourseat,loosenthesetscrewintheotherarm rest.Onthestandardseat,loosenthemountingscrewsinthe mountingblock,movethemountingblocktothe otherarm rest,andtightenthemountingscrews.Seefigure18.
9.Place the controller in the other armrest.
10.Tighten the setscrew(s) to secure the controller.
11.Use a wire tie to secure the controller cable to the armrest.
11.Plug the controller connector(s) into the power base.
12.Reinstall the rear shroud and tighten the fasteners.
SETSCREW
Figure 17. Underside of Armrest
MOUNTING | MOUNTING |
SCREWS | |
BLOCK |
|
SETSCREWS |
|
Figure 18. Adjusting Controller Position (Mounting Block Shown)
Quantum 500 | www.quantumrehab.com | 25 |