Invacare TDX SI manual Wheelchair Operation, Operating the Wheelchair, Turning the Power On/Off

Page 33

SECTION 5—WHEELCHAIR OPERATION

SECTION 5—WHEELCHAIR

OPERATION

WARNING

After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely - otherwise injury or damage may result.

Set-up of the Electronic Control Unit is to be performed only by a qualified techni- cian. The final adjustments of the controller may affect other activities of the wheel- chair. Damage to the equipment could occur under these circumstances.

Operating the Wheelchair

Turning the Power On/Off

NOTE: For this procedure, refer to FIGURE 5.1.

1. To turn the power On, perform one of the following steps:

JOYSTICK	ACTION

MPJ+	Move the On/Off switch Forward to the On position.

SPJ+	Press the On/Off button.

2. Turning the power Off can be achieved by performing one of the following steps:

JOYSTICK	ACTION

MPJ+	Move the On/Off switch Back to the Off position.

SPJ+	Press the On/Off button.

SPJ+ Joysticks

On/Off Button

MPJ+ Joystick

On/Off

Switch

FIGURE 5.1 Turning the Power On/Off

Using the Joystick to Drive the Wheelchair

NOTE: For this procedure, refer to FIGURE 5.2 on page 34.

The joystick is located on the joystick housing and provides smooth control of speed and direction. It is equipped with 360 degrees of mobility for ease of operation. The joystick is spring‐loaded, and automatically returns to the upright (neutral) position when released. Pushing the joystick in a given direction causes the wheelchair to move in that direction.

Part No 1154294

33

TDX® SI, TDX SI-HD

Image 33

Contents TDX SI TDX SI-HD Reference Documents Reference DocumentsManual Table of Contents Safety INSPECTION/TROUBLESHOOTING Wheel Locks Transport Ready Package Trro Register Your ProductSpecial Notes Special NotesMeaning Trro and Trbkts Warnings All Wheelchairs Label LocationsWheelchairs with 22NF Batteries Label LocationsWheelchairs with Trro Wheelchairs without Trro Typical Product Parameters Typical Product ParametersTDX SI HD General Guidelines Repair or Service InformationOperation Information General GuidelinesGeneral Guidelines Electrical Wheelchairs with Trro or Trbkts OnlyGrounding Instructions Charging Batteries BatteriesWeight Training Weight LimitationRain Test EMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance SAFETY/HANDLING of Wheelchairs Coping with Everyday Obstacles Stability AssistReaching, Leaning and Bending Reaching, Leaning and Bending ForwardPinch Points Reaching, Bending BackwardStairways Transferring To and From Other Seats Transferring To and From Other SeatsSafety Inspection Checklists Safety INSPECTION/ TroubleshootingInspect/Adjust Initially Safety INSPECTION/TROUBLESHOOTINGInspect/Adjust Monthly Inspect/Adjust WeeklyInspect/Adjust Periodically Troubleshooting MechanicalInspect/Adjust Every 18 Months Inspect/Adjust Every 2 YearsInformation Gauge Display Diagnostics Troubleshooting ElectricalSPJ+, SPJ+ w/PSS or SPJ+ w/ACC Joysticks Display Description DefinitionPossible Solution Service Indicator Light DiagnosticsSymptom Probable Cause Solutions MPJ+, PSR+, PSF+ Joysticks or DisplaysBAD Joystick CAL Values DON’T Checking Battery Charge LevelUsing the Joystick to Drive the Wheelchair Turning the Power On/OffWheelchair Operation Operating the WheelchairWheelchair Movement ActionSpeedometer On/Off ButtonSpeed Control Buttons Service IndicatorJoystick Charger/Programming InputDrive Select Toggle Switch MPJ+ Joystick Switches and IndicatorsSelecting the Drive Mode Information Gauge DisplayLCD Display Screens Speed ControlMain Screen Splash ScreenDriving Screen Wheelchair Operation DescriptionRemote Stop Switch Programmable Mono Port 1/2 or External Mode SwitchRemote Mode Reset Switch Connected Devices ScreenRemote On/Off Switch Mode SwitchMemory Card Slot Van Seats Repositioning JoystickAdjustable Asba Seats Disconnecting/Connecting the JoysticksDisconnecting SPJ+ JoysticksMPJ+ Joysticks ConnectingMotor Locks Disengaging/Engaging Motor Lock LeversMotor Locks Disengaging/Engaging the Wheel locks Wheel LocksEngaging DisengagingRemoving/Installing the Footboard Footboard AssemblyInstalling Pinch point may occur when rotating the footboard assemblyRemoving/Installing the Footboard Adjusting the Footboard AngleAdjusting Forks ForksForks Batteries BatteriesFor Wheelchairs Using 22NF Batteries Using the Proper BatteriesReplacing Batteries Wire CutterReplacing Batteries Removing/Installing the Batteries From/Into the Wheelchair Cleaning Battery TerminalsBattery Retention Bracket Removing the Batteries from Wheelchair Installing Batteries into WheelchairInstalling Batteries into Wheelchair When to Charge Batteries SPJ+, SPJ+ w/PSS and SPJ+ w/ACC JoysticksMPJ+ Joystick Charging Batteries Description and Use of Battery ChargersTool Quantity Required ItemsTransport Ready Package Trro Transport Ready Package TrroCompliance Information About Transport Ready PackagesMotor Wheelchair Weight Limit SpecificationsSecuring the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecurement Points Securing the WheelchairWheelchair-Anchored Belts Securing the OccupantWheelchair-Anchored Belts Rating Description Vehicle-Anchored BeltsPositioning Belts Seating SystemTDX SI, TDX SI-HD Limited Warranty Limited Warranty Global Limited Warranty Excluding CanadaUSA Canada Limited Warranty