Invacare TDX SI manual Charging Batteries, Description and Use of Battery Chargers

Page 60

SECTION 10—BATTERIES

Charging Batteries

WARNING

NEVER attempt to recharge the batteries by attaching cables directly to the battery terminals or clamps. ALWAYS use the recharging plug located on the back of the joystick.

DO NOT attempt to recharge the batteries and operate the power wheelchair at the same time.

During use and charging, unsealed batteries will vent hydrogen gas which is explosive in the right concentration with air.

CAUTION

Always charge new batteries before initial use or battery life will be reduced.

NOTE: For this procedure, refer to FIGURE 10.7 on page 61.

NOTE: New batteries MUST be fully charged prior to initial use of the wheelchair.

NOTE: As a general rule, batteries should be recharged daily to assure the longest possible life and minimize the required charging time. Plan to recharge the batteries when it is anticipated the wheelchair will not be used for a long period of time.

The range per battery charge using recommended batteries should be approximately 5 to 9 hours of typical operation. Extensive use on inclines may substantially reduce per charge mileage.

Description and Use of Battery Chargers

The charger automatically reduces the charge from an initially high rate to a zero reading at a fully charged condition. If left unattended, the charger should automatically shut‐off when full charge is obtained.

There are some basic concepts which will help you understand this automatic process. They are:

The amount of electrical current drawn within a given time to charge a battery is called the “charge rate”. If, due to usage, the charge stored in the battery is low, the charge rate is high, as indicated by the GREEN light on the charger. Initially, the GREEN light will stay illuminated for a short period of time followed by a longer period of off time. As a charge builds up, the charge rate is reduced, and the GREEN light will stay illuminated for a longer period of time followed by a shorter off time.

WARNING

NEVER leave the charger unattended when the breaker has tripped. A fault condition exists. Unplug and discontinue using immediately. Contact an Invacare dealer.

TDX® SI, TDX SI-HD

60

Part No 1154294

Image 60
Contents TDX SI TDX SI-HD Reference Documents Reference DocumentsManual Table of Contents Safety INSPECTION/TROUBLESHOOTING Wheel Locks Register Your Product Transport Ready Package TrroSpecial Notes Special NotesMeaning Trro and Trbkts Warnings Label Locations All WheelchairsWheelchairs with 22NF Batteries Label LocationsWheelchairs with Trro Wheelchairs without Trro Typical Product Parameters Typical Product ParametersTDX SI HD Repair or Service Information General GuidelinesOperation Information General GuidelinesGeneral Guidelines Electrical Wheelchairs with Trro or Trbkts OnlyGrounding Instructions Batteries Charging BatteriesWeight Training Weight LimitationRain Test EMI Information EMI InformationEMI Information SAFETY/HANDLING of Wheelchairs SAFETY/HANDLING of WheelchairsStability and Balance SAFETY/HANDLING of Wheelchairs Stability Assist Coping with Everyday ObstaclesReaching, Leaning and Bending Forward Reaching, Leaning and BendingReaching, Bending Backward Pinch PointsStairways Transferring To and From Other Seats Transferring To and From Other SeatsSafety INSPECTION/ Troubleshooting Safety Inspection ChecklistsInspect/Adjust Initially Safety INSPECTION/TROUBLESHOOTINGInspect/Adjust Weekly Inspect/Adjust MonthlyTroubleshooting Mechanical Inspect/Adjust PeriodicallyInspect/Adjust Every 18 Months Inspect/Adjust Every 2 YearsTroubleshooting Electrical Information Gauge Display DiagnosticsSPJ+, SPJ+ w/PSS or SPJ+ w/ACC Joysticks Display Description DefinitionService Indicator Light Diagnostics Possible SolutionSymptom Probable Cause Solutions MPJ+, PSR+, PSF+ Joysticks or DisplaysBAD Joystick CAL Values Checking Battery Charge Level DON’TTurning the Power On/Off Using the Joystick to Drive the WheelchairWheelchair Operation Operating the WheelchairMovement Action WheelchairOn/Off Button SpeedometerService Indicator Speed Control ButtonsJoystick Charger/Programming InputMPJ+ Joystick Switches and Indicators Drive Select Toggle SwitchSelecting the Drive Mode Information Gauge DisplaySpeed Control LCD Display ScreensSplash Screen Main ScreenWheelchair Operation Description Driving ScreenProgrammable Mono Port 1/2 or External Mode Switch Remote Stop SwitchRemote Mode Reset Switch Connected Devices ScreenRemote On/Off Switch Mode SwitchMemory Card Slot Repositioning Joystick Van SeatsDisconnecting/Connecting the Joysticks Adjustable Asba SeatsDisconnecting SPJ+ JoysticksConnecting MPJ+ JoysticksMotor Locks Disengaging/Engaging Motor Lock LeversMotor Locks Wheel Locks Disengaging/Engaging the Wheel locksEngaging DisengagingFootboard Assembly Removing/Installing the FootboardInstalling Pinch point may occur when rotating the footboard assemblyAdjusting the Footboard Angle Removing/Installing the FootboardAdjusting Forks ForksForks Batteries BatteriesUsing the Proper Batteries For Wheelchairs Using 22NF BatteriesWire Cutter Replacing BatteriesReplacing Batteries Cleaning Battery Terminals Removing/Installing the Batteries From/Into the WheelchairBattery Retention Bracket Installing Batteries into Wheelchair Removing the Batteries from WheelchairInstalling Batteries into Wheelchair When to Charge Batteries SPJ+, SPJ+ w/PSS and SPJ+ w/ACC JoysticksMPJ+ Joystick Description and Use of Battery Chargers Charging BatteriesRequired Items Tool QuantityTransport Ready Package Trro Transport Ready Package TrroAbout Transport Ready Packages Compliance InformationSpecifications Motor Wheelchair Weight LimitSecuring the Wheelchair to the Vehicle Positioning the Wheelchair in the VehicleSecuring the Wheelchair Securement PointsSecuring the Occupant Wheelchair-Anchored BeltsWheelchair-Anchored Belts Vehicle-Anchored Belts Rating DescriptionSeating System Positioning BeltsTDX SI, TDX SI-HD Limited Warranty Global Limited Warranty Excluding Canada Limited WarrantyCanada Limited Warranty USA