Invacare TDX SI manual Securing the Occupant, Wheelchair-Anchored Belts

SECTION 11—TRANSPORT READY PACKAGE (TRRO)

Securing the Occupant

Wheelchair-Anchored Belts

WARNING

The pelvic belt that is provided by Invacare has been tested for use in a motor vehicle on this wheelchair ONLY. DO NOT replace the pelvic belt with a different style pelvic belt.

NOTE: For this procedure, refer to FIGURE 11.2 on page 67.

The wheelchair has been provided with a pelvic belt which meets the requirements of ANSI/RESNA W/C 19.

The pelvic belt, provided by Invacare, has been designed to accommodate use on either side of the vehicle. If necessary, follow the instructions below to reverse the orientation of the pelvic belt to accommodate the vehicle‐anchored upper‐torso belt.

1.Install the pelvic belt pin (Detail “A” of FIGURE 11.2) into the large end of the slot in the belt mounting bracket (Detail “B” or Detail “C”). Rotate downward and forward until it snaps into place into the small end of the slot.

NOTE: Note the position of the male end of the belt when installing the pelvic belt onto the belt mounting brackets. The male end of the pelvic belt (Detail ʺAʺ of FIGURE 11.2) has a pin which is used to secure the vehicle‐anchored upper‐torso belt.

2.Repeat STEP 1 for the opposite belt mounting bracket.

3.Install the vehicle‐anchored upper‐torso belt onto the pin on the male end of the pelvic belt.

TDX® SI, TDX SI-HD 66 Part No 1154294